Hot Wheels Action Spiral Speed Crash Track Set
Please keep these instructions for future reference as they contain important information.
Colors and decorations may vary.
Adult assembly required.
Battery Installation
Unscrew the battery covers with a Phillips head screwdriver (not included). Install 4 new "D" size (LR20) 1.5V alkaline batteries (not included) in the battery boxes. Replace the battery covers and tighten screws. Replace batteries if the booster can no longer propel vehicles through the track set. For longer life, use alkaline batteries. When exposed to an electrostatic source, the product may malfunction. To resume normal operation, switch the power OFF for a few seconds, and then ON again.
Note: Do not turn on before assembly.
Power Switch: I = ON, O = OFF
Assembly - Zone 1
Parts Needed: B, Y, U, V, S, H, F, R, P, N, G, D, T8, Q1, L1, K4, E, C, A, Z, K1
- Assemble the base structure using parts B and Y.
- Attach the track pieces D and E to the base.
- Connect the vertical supports A, Z, and Y to the base.
- Attach the booster unit C to the base.
- Connect the remaining track pieces F, G, H, and J to complete Zone 1.
Assembly - Zone 2
Parts Needed: K2, K3, K4, L1, L2, L3, L4, N, P
- Connect track pieces K2, K3, and K4 to the existing structure.
- Attach the curved track pieces L1, L2, L3, and L4.
- Connect the supports N and P.
Assembly - Zone 3
Parts Needed: Q1, Q2, Q3, Q4, Q5, Q6, R, S
- Attach track pieces Q1, Q2, Q3, Q4, Q5, and Q6 to the structure.
- Connect the supports R and S.
Assembly - Zone 4
Parts Needed: T1, T2, T3, T4, T5, T6, T7, T8
- Connect the curved track pieces T1, T2, T3, T4, T5, T6, T7, and T8 to complete the spiral.
To Play
- Power On: Flip the switch to the 'ON' position.
- Load Cars: Load up to 5 cars for action!
- Launch Car: Launch a car through the booster.
Crash Zones: Observe the crash zones during play.
Note: One vehicle included. Additional vehicles sold separately. Not for use with some Hot Wheels vehicles.
Performance Tips
The booster automatically shuts off when it is jammed. To resume normal operation, switch it OFF for 30 seconds, and then ON again.
Tip: For longer life, use alkaline batteries.
More Ways to Play
Connect to other Hot Wheels tracks and sets for more challenges!
Note: Additional tracks and sets sold separately.