Etekcity EK6015 Digital Kitchen Scale

Thank You!

Thank you for purchasing the EK6015 Digital Kitchen Scale by Etekcity. Etekcity is dedicated to providing quality products for building a better living. For any questions or concerns, please contact the helpful customer support team at (855) 686-3835 or support@etekcity.com.

Table of Contents

• Safety Information
• Function Diagram
• Set-Up
• Operation
• Battery Replacement
• Troubleshooting
• Warranty Information
• Customer Support

Package Contents

• 1 x Digital Kitchen Scale
• 1 x Quick Start Guide
• 2 x 1.5V AAA batteries (Pre-installed)

Specifications

Safety Information

IMPORTANT

Please read and comply with all instructions and warnings provided in this manual before using the product. Failure to comply may result in inaccurate results and/or damage to the product.

Important Safety Information

• Always place the scale on a hard, dry, and flat surface for accurate measurement.
• DO NOT exceed the 5000g weight capacity. An overload indicator will appear on the LCD display if the limit is exceeded.
• DO NOT immerse the scale in water or corrosive liquids. If a liquid is spilled, immediately wipe the scale clean with a soft cloth to avoid potential damage.
• When replacing batteries, ensure correct polarity is observed as indicated in the battery compartment.
• Replace batteries if the low-battery indicator is displayed to ensure accuracy.
• DO NOT mix new and used batteries.
• This scale is not intended for commercial or heavy-duty use.
• When not in use, store the scale in a cool, dry environment.
• To clean, wipe the platform surface with a damp soft cloth.
• If the scale fails to turn on, check battery installation and replace if necessary.
• If the scale is not in use for an extended period, remove the batteries to extend their service lifetime.

Function Diagram

The scale features the following components:

• 1. LCD Display: Shows weight readings, units, and error messages.
• 2. Power / Auto-Tare Button (Z/T ON/OFF): Used to turn the scale on/off and to perform the tare function.
• 3. Unit Selection Button (UNIT): Cycles through available measurement units (e.g., grams, ounces, pounds).
• 4. Battery Compartment: Located on the underside, houses the batteries.
• 5. Anti-Skid Padding: Located on the underside to prevent the scale from sliding.

Set-Up

The included AAA batteries are preinstalled in the scale.

1. Open the battery compartment cover located on the backside of the scale.
2. Remove the plastic strip from the battery compartment to allow the batteries to power the device.
3. Reapply the battery compartment cover.

Operation

General Operation

1. Place the scale on a flat and level hard surface for measurement.
2. Press the ON/OFF button to turn on the scale. Wait until the screen displays zero before measuring.
3. Place the object of measurement on the center of the weighing platform.
4. Allow the scale to adjust to the weight of the object for a few seconds before it displays the final measured reading on the LCD screen.

Zero / Tare Function

The tare function allows you to measure objects in a container without having to include the container's weight in the final measurement.

1. Turn on the scale and wait for the screen to display zero. If the screen does not display zero automatically, press the Z/T button to auto-adjust to zero.
2. Place the desired object (e.g., a container) which is to be excluded from the final weight, on the center of the measuring platform.
3. Press the Z/T button to tare the current weight of the object. The screen should now display zero.
4. Place the desired item(s) to be weighed on the center of the measuring platform or within the tared container to calculate the net weight of the desired item(s).

Unit Conversion

To change the unit of measurement, press the UNIT button until the LCD display indicates the desired unit of measurement.

Automatic Power Off

For battery power conservation, the display backlight will automatically power off after 30 seconds of inactivity. Additionally, the scale itself will automatically power off after 2 minutes of inactivity.

Manual Power Off

Press and hold the ON/OFF button for 2 seconds to manually turn off the digital scale at any time.

Battery Replacement

1. Open the battery compartment cover on the backside of the scale.
2. Take out the used batteries and dispose them properly.
3. Install new 1.5V AAA batteries, taking note of the correct polarity displayed in the battery compartment.
4. Reseal the battery compartment.

Troubleshooting

Warranty

Product Name: EK6015 Digital Kitchen Scale

Default Warranty Period: 2 years

Etekcity Corporation ("Etekcity") warrants this product to the original purchaser to be free from defects in material and workmanship, under normal use and conditions, for a period of 2 years from the date of original purchase.

Etekcity agrees, at its option during the warranty period, to repair any defect or furnish an equal product in exchange without charge, subject to verification of the defect and proof of purchase.

This warranty does not apply if the product has been modified, not used according to instructions, damaged by accident or misuse, serviced by unauthorized personnel, used commercially, or if damages exceed the product cost.

Etekcity is not liable for indirect, incidental, or consequential damages.

This warranty extends only to the original consumer purchaser and is not transferable.

Warranty does not extend to products purchased from unauthorized sellers. Implied warranties are limited to the period of this limited warranty.

For warranty service, contact Customer Support via support@etekcity.com. Register your product online at www.etekcity.com/warranty.

Warranty is made by: Etekcity Corporation, 1202 N. Miller St., Suite A, Anaheim, CA 92806, USA.

Customer Support

If you encounter any issues or have questions, contact the Etekcity Customer Support Team. Your satisfaction is our goal!

Customer Support:

Etekcity Corporation
1202 N. Miller St., Suite A
Anaheim, CA 92806
USA

Email: support@etekcity.com

Toll-Free: (855) 686-3835

Support Hours: Monday–Friday, 9:00 am–5:00 pm PST/PDT

*Please have your invoice and order number ready before contacting Customer Support.