Trust Tytan 2.1 Speaker Set User Guide

TYTAN 2.1 Speaker Set

This guide provides instructions for setting up and using your Trust Tytan 2.1 speaker set.

The following languages are supported in this manual: German, French, Dutch, Italian, Spanish, Portuguese, Swedish, Finnish, Norwegian, Polish, Czech, Slovak, Hungarian, Romanian, Russian, Turkish.

Setup Instructions

Connection Diagram

Step 1: Connecting the satellite speakers to the subwoofer.

Connect the left and right satellite speakers to the corresponding audio output ports on the back of the subwoofer. These ports are typically color-coded or labeled.

Diagram Description: Two small satellite speakers are shown connected via cables to a larger subwoofer. The connection points on the subwoofer are indicated by circular ports.

Step 2: Connecting the audio source to the subwoofer.

Connect your audio source (e.g., computer, smartphone) to the audio input port on the subwoofer. This is usually a 3.5mm audio jack.

Diagram Description: An audio source device (represented by a small box with an audio jack) is shown connected to the input port on the subwoofer.

Power and Standby

Step 3: Powering on and standby mode.

Ensure all connections are secure. The system will enter standby mode when there is no audio input for 80 minutes. To resume, a new audio signal is required.

Diagram Description: An arrow points from 'NO SOUND' to an '80m' icon (representing 80 minutes) and then to 'STANDBY'.

Troubleshooting

No Sound

If you experience no sound:

• Check all cable connections to ensure they are secure.
• Verify that the volume is turned up on both the speaker system and your audio source.
• Ensure the speaker system is not in standby mode.
• Confirm that the correct audio output is selected on your audio source device.