Installation Manual

Part 0 Manual Administration

0.1 Document Approval

This document has been established in accordance with an alternative procedure to DOA approved under EASA AP429. This installation manual is applicable for part numbers:

• EyeBeam Mini - Silver / Silver Faceplate (AVE-EMB3S-00T)
• EyeBeam Mini - Silver / Black Faceplate (AVE-EMB4S-00T)
• EyeBeam Mini - Black / Silver Faceplate (AVE-EMB4B-00T)
• EyeBeam Mini - Black / Black Faceplate (AVE-EMB3B-00T)

Compiled by: Petr Jaroš, Engineer, Aveo Engineering Group, s.r.o. (14. Apr. 2021)

Approved by: Georg Hartl, Head of DO, Aveo Engineering Group, s.r.o. (14. Apr. 2021)

0.2 Amendment Record Procedure

The master copy of this document is kept electronically as a read-only document under the control of Aveo Engineering Group, s.r.o. All amendments initiate a raise of issue, sequentially numbered from 01 to 99. All issues are approved by the Head of DO.

0.3 Affected Pages Procedure

All pages affected by any raise of issue will be listed in the 'Affected Pages' column of Table 01. Reasons for and descriptions of changes will be provided in the 'Details' column. Changes from previous issues are highlighted by YELLOW HIGHLIGHTING over new content and YELLOW HIGHLIGHTING AND CROSSING OUT of deleted content.

Part 1 Installation Data

1.1 EyeBeam Mini

The EyeBeam Mini™ is an interior swivel LED light with TOUCH sensing control, available in black or natural anodized finish.

Description of product image: A close-up photograph of the Aveo Engineering EyeBeam Mini light, showcasing its sleek design with a central metallic dial and illuminated touch-sensitive controls around the perimeter. The dial features a power symbol [⏻] and +/- indicators [➕] [➖] for brightness.

• EyeBeam Mini - Silver / Silver Faceplate (AVE-EMB3S-00T)
• EyeBeam Mini - Silver / Black Faceplate (AVE-EMB4S-00T)
• EyeBeam Mini - Black / Silver Faceplate (AVE-EMB4B-00T)
• EyeBeam Mini - Black / Black Faceplate (AVE-EMB3B-00T)

1.2 Operating Instructions

Operating Voltage range is 9-36VDC. When installed on the aircraft, using the aircraft's power (14 or 28 volts), the light will be at its maximum intensity.

Description of touch control interface diagram: Illustrates the EyeBeam Mini's touch controls, labeling the 'ON/OFF switch' [⏻] and 'BRIGHTNESS slider' [➕] [➖].

1.3 Installation Schematic / Wiring Diagram

Description of wiring diagram: A schematic shows the power connection for the EyeBeam Mini. It includes a power source labeled '9-36 VDC', connected through a 'Fuse' (0.5 A) and a 'Switch' to the light unit.

1.4 Control & Power Inputs

BLACK wire: Negative power supply line (ground)

RED wire: Positive power supply line

1.5 Technical Specification

Electronic specification - Ambient temperature (25°C):

• Operating voltage range: 9-36V DC
• Dimensions: See section #1.6 – Technical Drawing
• Performance:
  • Input current (Min): 0.01A @14V, 0.01A @28V
  • Input current (Max): 0.16A @14V, 0.10A @28V
  • Input power (Min): 0.1W @14V (typ), 0.3W @28V (typ)
  • Input power (Max): 2.2W @14V (typ), 2.8W @28V (typ)
• Operating temperature: -40°C to +85°C / -40°F to +185°F
• Weight: 3.35 oz / 95 g

1.6 Technical Drawing

Description of technical drawing: Provides dimensions for the EyeBeam Mini. Includes front view with mounting hole details (63 mm / 2.48" diameter) and side views showing depths of 20 mm (0.787") and 19 mm (0.748"). A separate diagram details the panel cutout for mounting, including angles and dimensions in mm [inches].

1.7 Wiring Chart

Use the diagram to define the wiring size based on current and wire length. Ensure the current for all connected lights is summed. If current is not provided, divide power by voltage. The chart also includes notes on voltage drop and conductor temperature.

Description of wiring chart: A grid correlating wire length (in feet) and circuit voltage (14V, 28V) with wire size and current (Amperes). It also references voltage drop and conductor temperature considerations.

1.8 Optic Simulation

Standard lens, White LED.

Description of optic simulation polar plots: Two 'Candela Polar Plot' graphs illustrate the light intensity distribution. One shows maximum intensity of approximately 317 cd, and the other shows minimum intensity of approximately 32 cd.

1.9 Equipment Limitation

EyeBeam Mini™ should only be powered by 9-36VDC.

1.10 Care and Cleaning of your Aveo Engineering Aviation Lights

Upon receipt, Aveo Engineering Aviation Lights are factory polished and ready for installation. For deeper cleaning, use a quality lamb's wool sheet for polishing. Do not use any petroleum-based products for cleaning.

1.11 Testing of the Light Before Installation

All Aveo Aviation lights undergo rigorous testing, including burn-in time and functional testing, before release. To test the EyeBeam Mini™ light before installation:

1. Review the written information enclosed in the packaging, including warranty information and cautionary notes about power supply removal.
2. Remove the light from the package. Note the two wires: Black (-) Negative lead, Red (+) Positive lead.
3. Test the light's function using a regular 14V or 28V/5A DC power supply (not a battery charger). Connect the black wire to the power supply's negative lead and the red wire to the positive lead. The EyeBeam Mini light should illuminate. When installed on an aircraft, it will operate at maximum intensity using the aircraft's 14V or 28V power.

IMPORTANT NOTES:

• Use only a 9-36 VDC power supply or a 14 or 28 volt battery for testing. Do not use battery chargers, battery back-up power devices, or other bench avionics testing methods. Using a battery charger or other power unit will void the warranty and may damage the light.

For questions regarding installation, please visit the Aveo Engineering website: www.aveoengineering.com.

1.12 Notes on Installation

Mount the EyeBeam Mini as described in the following diagram.

Description of installation diagram: Shows the mounting procedure for the EyeBeam Mini. Includes a 'Tightening Nut' securing the light to a 'Ceiling / Wall' panel, with a maximum panel thickness specified as 15 mm (0.59").

1.13 Continues Airworthiness Information

Periodic Inspection Procedure for EyeBeam Mini series:

Check the EyeBeam Mini™ lights for proper operation during preflight. This information is typically included in general aviation aircraft flight manuals. Visually inspect the lights for general condition, proper operation, and correct installation at each annual and/or 100 hours inspection. Refer to section 1.10 for detailed cleaning instructions.

1.14 RoHS Compliance Statement

Scope: This statement clarifies Aveo Engineering's compliance with European Union Directive 2015/863/EU on the restriction of the use of certain hazardous substances in electrical and electronic equipment ("RoHS"), effective June 4, 2015. The directive restricts substances including:

• Cadmium(Cd): 0.01%
• Mercury: 0.1%
• Lead(Pb) : 0.1%
• Hexavalent chromium (Cr6+) : 0.1%
• Polybrominated biphenyls (PBB): 0.1%
• Polybrominated diphenyl ethers (PBDE): 0.1%
• Bis(2-Ethylhexyl) phthalate (DEHP): 0.1% (added in 2015)
• Benzyl butyl phthalate (BBP): 0.1% (added in 2015)
• Dibutyl phthalate (DBP): 0.1% (added in 2015)
• Diisobutyl phthalate (DIBP): 0.1% (added in 2015)

Compliance: Aveo Engineering certifies that its products comply with environmental standards set forth by Directive 2015/863/EU (recast amendment of RoHS Directive 2011/65/EU Article 4) and do not contain the specified hazardous substances above the limits. All Aveo Engineering products are RoHS-compliant. RoHS-2 CE marking on packaging indicates conformity if required.

References: Directive 2015/863/EU of the European Parliament and of the Council on the restriction of the use of certain hazardous substances in electrical and electronic equipment.

1.15 EU REACH Regulation (EC) No. 1907/2006

Aveo Engineering declares that no chemicals are produced, and none of the chemicals used in production, maintenance, or service, are listed on the European Chemicals Agency's Candidate list of Substances of Very High Concern for Authorization.