Dual XD5110 AM/FM/CD Receiver

Product Overview

This manual provides comprehensive instructions for the installation and operation of the Dual XD5110 AM/FM/CD Receiver. It covers preparation, installation steps, wiring, control locations, general operation, tuner functions, CD player functions, specifications, troubleshooting, and warranty information.

Front view of the Dual XD5110 car stereo receiver, showing the display, tuning knob, volume control, various buttons (PWR, TUNE, VOL, BASS, BAND, LOC, MONO, INT, RND, RPT, DISP, AUD, RESET), CD slot, and speaker outputs.

Preparation

Please read the entire manual before installation.

Before You Start

• Disconnect the negative battery terminal. (Consult a qualified technician for instructions)
• Avoid installing the unit where it would be subject to high temperatures, direct sunlight, dust, dirt, or excessive vibration.

Getting Started

• Remove the 2 transit screws located on top of the unit.
• Remove the trim ring by pulling up gently in the center.
• Insert the supplied keys into the slots and slide the unit out of the mounting sleeve.
• Install the mounting sleeve into the opening, bending tabs to secure.
• Connect the wiring harness and antenna. (Consult a qualified technician if you are unsure)
• Certain vehicles may require an installation kit and/or wiring harness adapter (sold separately).
• Test for correct operation and slide the unit into the mounting sleeve to secure.
• Snap the trim ring into place.

Installation

Diagram showing the unit being slid out of a mounting sleeve using keys, with the trim ring detached.

Diagram illustrating the typical mounting method: The unit is secured using a mounting strap, hex bolt, washers (hex nut, plain washer, spring washer), and tapping screw.

Wiring Diagram

Schematic showing the rear connections of the XD5110:

• Antenna Connector: Standard antenna input.
• RCA Cable (sold separately): GRAY Rear Preamp Output connects to amplifier RCA Input.
• BLUE Remote Turn-On: Connects to amplifier or power antenna. Insulate wire if not used.
• BLACK Ground: Connects to vehicle chassis ground.
• RED Accessory: Connects to ignition circuit or switched 12V source.
• YELLOW Memory: Connects to battery circuit or constant 12V source.

Speaker Connections:

• Right Front: Gray/Black (-) Gray (+)
• Right Rear: Violet/Black (-) Violet (+)
• Left Front: White/Black (-) White (+)
• Left Rear: Green/Black (-) Green (+)

Fuses

When replacing fuses, ensure the new fuse is the correct type and amperage. Using an incorrect fuse could damage the radio. The XD5110 uses one 1 amp AGC fuse (Ignition) and one 5 amp AGC fuse (Battery) located in-line.

Caution: Do not attach any speaker leads to ground as severe damage will occur.

Control Locations

Front view of the XD5110 with numbered controls.

1. Power
2. Volume
3. Track Up/Down
4. Eject
5. Band
6. Display
7. Local/Distance/CD Repeat
8. Play/Pause
9. Bass Boost/CD Random
10. Mono/Stereo/CD Intro
11. Reset
12. Audio
13. Tuning

General Operation

Power On/Off

Press PWR to turn the unit on. Inserting a CD will turn the unit on automatically. Press PWR to turn the unit off.

CD Mode

Insert a CD or press [play-pause] to begin or resume playback.

Tuner Mode

Press PWR or BAND to begin or resume tuner operation.

Bass Boost

Press BASS to activate and deactivate bass boost. Activating this feature will enhance the bass frequencies when listening to music at low volumes.

Volume

Adjust volume using [volume-up] or [volume-down] (0-63).

Display

Press DISP to display the clock. The radio frequency (tuner mode) or CD track/elapsed time (CD player mode) show by default.

Set the Clock

Press and hold DISP until the clock begins to flash, then release. Press [track-backward] to adjust the hours and [track-forward] to adjust the minutes. Press DISP momentarily to save the selected time.

Reset

Press and hold for more than 2 seconds to RESET the unit upon initial installation or if abnormal operation occurs.

Audio Adjustments

Press AUD to select between Volume (default), Bass, Treble, Balance & Fader.

• Bass: Press AUD until BAS appears. Adjust with [volume-up] or [volume-down] (7 maximum / -7 minimum).
• Treble: Press AUD until TRE appears. Adjust with [volume-up] or [volume-down] (7 maximum / -7 minimum).
• Balance: Press AUD until BAL appears. Adjust with [balance-left] or [balance-right] (BA.L 10/BA.R 10). BAL 0 represents equal balance.
• Fader: Press AUD until FAD appears. Adjust with [fader-front] or [fader-rear] (FA.F 10/FA.R 10). FAD 0 represents equal fader.

Tuner Operation

Tuning

Turn TUNE knob to select desired station.

FM Mono/Stereo

Press MONO during FM tuner operation to select mono or stereo (default) reception of the broadcast signal.

Local/Distance

Press LOC to activate local tuning for strong station reception only. Press LOC again to cancel and resume Distance tuning (default).

Band

Press BAND to select between FM and AM bands.

CD Player Operation

Insert CD

With the label facing up, insert a standard CD into the CD slot. The CD will automatically begin playback.

Eject CD

Press the EJECT button to stop and eject the CD. The unit will change to tuner mode. If the disc is not removed within 10 seconds, the unit will reload the disc.

Track Select

Press [track-forward] to skip to the beginning of the next track. Press [track-backward] to return to the beginning of the current track. Pressing [track-backward] again skips to the beginning of the previous track.

Fast Forward and Reverse

Press and hold [track-backward] or [track-forward] to fast forward or reverse a track.

Pause

Press [play-pause] to temporarily stop CD playback. Press [play-pause] again to resume playback.

Intro

Press INT to play the first 10 seconds of each track. Press INT to cancel.

Repeat

Press RPT to continuously repeat selected track. Press RPT to cancel.

Random

Press RDM for more than 2 seconds to play all tracks in random order. Press RDM again for more than 2 seconds to cancel.

CD-R/CD-RW Compatibility

Some CD-Rs and CD-RWs may be incompatible with this unit, depending on media type and recording method.

Specifications

CD Player

• Signal-to-noise: >86dB
• Frequency response: 20Hz-20kHz
• Channel separation @ 1kHz: >65dB
• D/A converter: 1 Bit

FM Tuner

• Tuning range: 87.5MHz-107.9MHz
• Usable sensitivity: 12dBf
• 50dB quieting sensitivity: 16dBf
• Stereo separation @ 1kHz: 40dB
• Frequency response: 30Hz-13kHz

AM Tuner

• Tuning range: 530kHz-1720kHz
• AM sensitivity: 30uV
• Frequency response: 80Hz-2kHz

General

• Total power output: 100 Watts Peak
• Power output: 25Wx4 @ 4 ohms, 14.4 VDC
• Operating voltage: 11-16 VDC, negative ground
• Speaker output impedance: 4~8 ohms
• Fuses: 1 amp fast blow AGC, 5 amp fast blow AGC
• Dimensions: 7" x 7" x 2" (178 x 178 x 51 mm)

Design and specifications subject to change without notice.

Troubleshooting

Contact Information

Namsung America Inc.
21318 64th Ave. South
Kent, WA 98032
Toll Free: 1-866-626-7863
Website: www.dualav.com

©2004 Namsung America, Inc.

Warranty Information

Limited One-Year Warranty

This warranty gives you specific legal rights. You may also have other rights which vary from state to state.

Namsung America Inc. warrants this product to the original purchaser to be free from defects in material and workmanship, under normal conditions, for a period of one year from the date of the original purchase.

Namsung America agrees, at its option, during the warranty period, to repair any defect in material or workmanship or to furnish an equal new or renewed product in exchange without charges, subject to verification of the defect or malfunction and proof of the date of purchase.

During the One-Year Warranty Period: For One Year from the date of purchase, your product will be replaced with a new, renewed, or comparable product (whichever is deemed necessary) if it becomes defective or inoperative. This is done without charge to you. Replacement products are warranted for the balance of the original warranty period.

Who is covered?

This warranty is extended to the original retail purchaser for products purchased and used in the U.S.A., in the 48 contiguous states ONLY.

What is covered?

This warranty covers all defects in material and workmanship in this product. The following are not covered:

• Installation/removal costs
• Damage resulting from accident, misuse, abuse, neglect, product modification, improper installation, incorrect line voltage, unauthorized repair, or failure to follow instructions supplied with the product, or damage occurring during return shipment of the product.

What to do?

If the product requires warranty service, you must prepay the initial shipping charges. DUAL will pay the return shipping charges if the product is returned to an address within the USA.

Contact for Service:
Namsung America Inc.
Attn: Returns Center
21318 64th Ave. South
Kent, WA 98032 U.S.A.
Toll Free: 1-866-626-7863

Exclusion of Certain Damages

This warranty is exclusive and in lieu of any and all other warranties, expressed or implied, including without limitation the implied warranties of merchantability and fitness for a particular purpose and any obligation, liability, right, claim or remedy in contract or tort, whether or not arising from the company's negligence, actual or imputed. No person or representative is authorized to assume for the company any other liability in connection with the sale of this product. In no event shall the company be liable for indirect, incidental or consequential damages.