VTech Marble Rush™ Raceway Set
Instruction Manual
Introduction
Thank you for purchasing the Marble Rush™ Raceway Set! Get ready for a rush of non-stop action! Build thrilling courses, send the marbles into motion and compete with family and friends through exciting challenges complete with sounds and lights.
WARNING
All packing materials such as tape, plastic sheets, packaging locks, removable tags, cable ties, cords and packaging screws are not part of this toy, and should be discarded for your child's safety.
NOTE
Please save this Instruction Manual as it contains important information.
ATTENTION
Pour la sécurité de votre enfant, débarrassez-vous de tous les produits d'emballage tels que rubans adhésifs, feuilles de plastique, attaches, étiquettes, cordons et vis d'emballage. Ils ne font pas partie du jouet.
NOTE
Il est conseillé de conserver ce guide car il comporte des informations importantes.
Getting Started
Battery Removal and Installation
- Make sure the Starting Gate is turned Off.
- Find the battery cover located on the back of the unit, use a coin or screwdriver to loosen the screw and then open the battery cover.
- Remove old batteries by pulling up on one end of each battery.
- Install 2 new AA (AM-3/LR6) batteries following the diagram inside the battery box. (For best performance, alkaline batteries or fully charged Ni-MH rechargeable batteries are recommended).
- Replace the battery cover and tighten the screw to secure.
IMPORTANT: BATTERY INFORMATION
- Insert batteries with the correct polarity (+ and -).
- Do not mix old and new batteries.
- Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.
- Only batteries of the same or equivalent type as recommended are to be used.
- Do not short-circuit the supply terminals.
- Remove batteries during long periods of non-use.
- Remove exhausted batteries from the toy.
- Dispose of batteries safely. Do not dispose of batteries in fire.
RECHARGEABLE BATTERIES
- Remove rechargeable batteries (if removable) from the toy before charging.
- Rechargeable batteries are only to be charged under adult supervision.
- Do not charge non-rechargeable batteries.
WARNING
CHOKING HAZARD -Toy contains small parts and small balls. Not for children under 3yrs.
WARNING:
Adult assembly required for battery installation. Keep batteries out of reach of children.
ATTENTION :
Les piles ou accumulateurs doivent être installés par un adulte. Tenir les piles ou accumulateurs hors de portée des enfants.
WARNING
Do not aim at eyes or face.
WARNING
Do not discharge any object other than the projectile provided with this toy.
ATTENTION
Ne viser ni les yeux ni le visage.
ATTENTION
Ne pas utiliser d'autres projectiles que ceux fournis avec ce jouet.
Label Application
Please securely stick the labels to the playset as indicated below:
A visual representation of label placement is provided, showing numbered labels (1-14) to be applied to various parts of the Marble Rush™ Raceway Set.
Product Components
The following components are included in the Marble Rush™ Raceway Set:
- M-19: Starting Gate with lights and sound
- T-05: Green curved track piece
- T-03: Orange curved track piece
- T-04: Red curved track piece
- T-16: Green straight track piece with arrow indicators
- T-01: Yellow curved track piece
- T-02: Orange curved track piece
- M-01: Launcher mechanism
- M-07: Yellow base piece
- B-02: Orange building block
- B-04: White building block
- B-05: Red building block
Product Features
- Starting Gate: When a marble passes through the Starting Gate, lights will flash and the unit will play sound effects.
- Starting Gate Button: Press this button to change the music.
- Off/Sound Switch: Slide the switch to the top position to turn on both music and sound effects. Slide the switch to the middle position to play only the sound effects. Slide the switch to the bottom position to turn the unit off.
- Automatic Shut-Off: To preserve battery life, the Marble Rush™ Raceway Set will automatically turn off after several minutes without input. The unit can be turned on again by sliding the switch to the Sound position. The unit will also automatically turn off when the batteries are very low. If the unit powers down while playing, install a new set of batteries.
Care & Maintenance
- Keep the unit clean by wiping it with a slightly damp cloth.
- Keep the unit out of direct sunlight and away from any direct heat sources.
- Remove the batteries if the unit will not be used for an extended period of time.
- Do not drop the unit on hard surfaces or expose the unit to moisture or water.
Troubleshooting
If for some reason the unit is not working or malfunctions, please follow these steps:
- Turn the unit Off.
- Interrupt the power supply by removing the batteries.
- Let the unit stand for a few minutes, then replace the batteries.
- Turn the unit On. The unit should now be ready to play again.
- If the unit still does not work, install a brand new set of batteries.
Important Note
If the problem persists, please call our Consumer Services Department at 1-800-521-2010 in the U.S., 1-877-352-8697 in Canada, or by going to our website vtechkids.com and filling out our Contact Us form located under the Customer Support link. Creating and developing VTech products is accompanied by a responsibility that we take very seriously. We make every effort to ensure the accuracy of the information, which forms the value of our products. However, errors sometimes can occur. It is important for you to know that we stand behind our products and encourage you to contact us with any problems and/or suggestions you might have. A service representative will be happy to help you.
FCC Compliance
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
CAN ICES-003(B)/NMB-003(B)
Caution
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Supplier's Declaration of Conformity
47 CFR § 2.1077 Compliance Information
Trade Name: VTech®
Model: 5193
Product Name: Marble Rush™ Raceway Set
Responsible Party: VTech Electronics North America, L.L.C.
Address: 1156 W. Shure Drive, Suite 200, Arlington Heights, IL 60004
Website: vtechkids.com
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
Visit our website for more information about our products, downloads, resources and more.
Read our complete warranty policy online at
TM & © 2022 VTech Holdings Limited. All rights reserved.
IM-519300-000 Version:0
