Built-in Oven Safety and Installation Guide

Built-in Oven Safety and Installation Guide

Important Safety Instructions

Before using the appliance, read these safety instructions carefully and keep them nearby for future reference. The manufacturer declines any liability for failure to observe these safety instructions, inappropriate use of the appliance, or incorrect setting of controls.

  • WARNING: The appliance and its accessible parts become hot during use. Avoid touching heating elements.
  • Very young children (0-3 years) should be kept away. Young children (3-8 years) should be kept away unless continuously supervised.
  • Children from 8 years old and above, and persons with reduced physical, sensory, or mental capabilities or lack of experience and knowledge, can use this appliance only if supervised or instructed on safe use and understanding of hazards.
  • Children must not play with the appliance. Cleaning and user maintenance must not be carried out by children without supervision.
  • Never leave the appliance unattended during food drying. If suitable for probe usage, only use a temperature probe recommended for this oven to avoid fire risk.
  • Keep clothes or other flammable materials away from the appliance until all components have cooled down completely to avoid fire risk.
  • Be vigilant when cooking foods rich in fat, oil, or when adding alcoholic beverages to avoid fire risk.
  • Use oven gloves to remove pans and accessories.
  • At the end of cooking, open the door with caution, allowing hot air or steam to escape gradually before accessing the cavity to avoid burn risk.
  • Do not obstruct hot air vents at the front of the oven to avoid fire risk.
  • Exercise caution when the oven door is in the open or down position to avoid hitting the door.
  • Food must not be left in or on the product for more than one hour before or after cooking.
  • Do not store explosive or flammable substances (e.g., gasoline or aerosol cans) inside or near the appliance to avoid fire risk.

Installation Guidelines

  • The appliance must be handled and installed by two or more persons to avoid injury. Use protective gloves to unpack and install to avoid cuts.
  • Installation, including water supply (if any), electrical connections, and repairs, must be carried out by a qualified technician.
  • Do not repair or replace any part of the appliance unless specifically stated in the user manual.
  • Keep children away from the installation site.
  • After unpacking, ensure the appliance has not been damaged during transport. In case of problems, contact the dealer or nearest After-sales Service.
  • Once installed, packaging waste (plastic, styrofoam parts, etc.) must be stored out of reach of children to avoid suffocation.
  • WARNING: The appliance must be disconnected from the power supply before any installation operation to avoid electrical shock.
  • During installation, ensure the appliance does not damage the power cable to avoid fire or electrical shock.
  • Only activate the appliance when installation is complete.
  • Carry out all cabinet cutting works before fitting the appliance and remove all wood chips and sawdust.
  • Do not remove the appliance from its polystyrene foam base until installation time.
  • After installation, the bottom of the appliance must no longer be accessible to avoid burn risk.
  • Do not install the appliance behind a decorative door to avoid fire risk.
  • If installed under the worktop, do not obstruct the minimum gap between the worktop and the upper edge of the oven to avoid burn risk.

Appliance Dimensions and Cabinet Cutout

The following dimensions are provided for installation planning:

ComponentDimensionValue (mm)
Oven WidthOverall557
Oven HeightOverall530
Oven DepthOverall549
Front Panel WidthVisible423
Front Panel HeightVisible97
Cabinet Cutout WidthMinimum560
Cabinet Cutout HeightMinimum560
Cabinet Cutout DepthMinimum595
Door Opening AngleMaximum89°
Tall Unit Cabinet HeightMinimum589 (+2)

Installation Steps Illustrated

  • Step 1: Prepare the cabinet opening according to the minimum dimensions.
  • Step 2: Lift the oven into the cabinet opening with the assistance of at least two people.
  • Step 3: Secure the oven to the cabinet using the provided screws (typically 2 screws).
  • Step 4: Ensure proper electrical connection.

Permitted Use

  • CAUTION: The appliance is not intended to be operated by means of an external switching device, such as a timer, or separate remote-controlled system.
  • This appliance is intended for household and similar applications such as: staff kitchen areas in shops, offices, and other working environments; farm houses; by clients in hotels, motels, bed & breakfast, and other residential environments.
  • No other use is permitted (e.g., heating rooms).
  • This appliance is not for professional use. Do not use the appliance outdoors.

Electrical Warnings

  • The rating plate is on the front edge of the oven (visible when the door is open).
  • It must be possible to disconnect the appliance from the power supply by unplugging it (if plug is accessible) or by a multi-pole switch installed upstream of the socket, in accordance with wiring rules.
  • The appliance must be earthed in conformity with national electrical safety standards.
  • Do not use extension leads, multiple sockets, or adapters.
  • The electrical components must not be accessible to the user after installation.
  • Do not use the appliance when wet or barefoot.
  • Do not operate if the power cable or plug is damaged, if it is not working properly, or if it has been damaged or dropped.
  • If the supply cord is damaged, it must be replaced with an identical one by the manufacturer, its service agent, or similarly qualified persons to avoid electrical shock hazard.
  • If the power cable needs replacement, contact an authorized service center.

Cleaning and Maintenance

  • WARNING: Ensure the appliance is switched off and disconnected from the power supply before performing any maintenance operation.
  • To avoid personal injury, use protective gloves (risk of laceration) and safety shoes (risk of contusion).
  • Handle by two persons to reduce load.
  • Never use steam cleaning equipment (risk of electric shock).
  • Non-professional repairs not authorized by the manufacturer could result in a health and safety risk, for which the manufacturer cannot be held liable. Any defect or damage from non-professional repairs or maintenance will not be covered by the guarantee.
  • Do not use harsh abrasive cleaners or metal scrapers to clean the door glass, as they can scratch the surface, which may result in shattering of the glass.
  • Make sure the appliance has cooled down before cleaning or performing maintenance to avoid burn risk.
  • WARNING: Switch off the appliance before replacing the lamp to avoid electrical shock.

Disposal Information

Disposal of Packaging Materials

The packaging material is 100% recyclable and is marked with the recycle symbol ♻. The various parts of the packaging must therefore be disposed of responsibly and in full compliance with local authority regulations governing waste disposal.

Disposal of Household Appliances

This appliance is manufactured with recyclable or reusable materials. Dispose of it in accordance with local waste disposal regulations. For further information on the treatment, recovery, and recycling of household electrical appliances, contact your local authority, the collection service for household waste, or the store where you purchased the appliance.

This appliance is marked in compliance with European Directive 2012/19/EU, Waste Electrical and Electronic Equipment (WEEE), and with the Waste Electrical and Electronic Equipment regulations 2013 (as amended). By ensuring this product is disposed of correctly, you will help prevent negative consequences for the environment and human health. The symbol ♻ on the product or on the accompanying documentation indicates that it should not be treated as domestic waste but must be taken to an appropriate collection center for the recycling of electrical and electronic equipment.

Energy Saving Tips

  • Only preheat the oven if specified in the cooking table or your recipe.
  • Use dark lacquered or enameled baking trays as they absorb heat better.
  • Food requiring prolonged cooking will continue to cook even once the oven is switched off.

Declarations of Conformity

This appliance meets: Ecodesign requirements of European Regulation 66/2014; Energy Labelling Regulation 65/2014; Ecodesign for Energy-Related Products and Energy Information (Amendment) (EU Exit) Regulations 2019, in compliance with the European standard EN 60350-1.

This product contains a light source of energy efficiency class G.

Models: 5B10B0040, 5B10B0040 Built In Electric Oven, Built In Electric Oven, Electric Oven, Oven

File Info : application/pdf, 16 Pages, 475.58KB

PDF preview unavailable. Download the PDF instead.

Installation-instructions-5B10B0040 Acrobat Distiller 24.0 (Windows)

Related Documents

Preview Built-in Oven - User Manual and Installation Guide - 400011709424
Comprehensive safety instructions, installation guide, cleaning and maintenance procedures, and energy-saving tips for the 400011709424 built-in oven. Includes warnings, permitted use, electrical safety, and disposal information.
Preview Oven Installation and Safety Manual (Model 400011708241)
Comprehensive safety, installation, operation, and maintenance guidelines for the 400011708241 oven. Includes essential warnings and instructions for safe use and setup.
Preview Oven Installation and Safety Guide
Comprehensive guide for the safe installation, operation, and maintenance of an oven, including safety instructions, permitted uses, and energy-saving tips.
Preview Built-in Oven Safety, Installation, and User Manual
Comprehensive guide for safe installation, operation, cleaning, and disposal of your built-in oven, including important safety warnings and energy-saving tips. This manual covers electrical safety, permitted use, and maintenance procedures.
Preview Oven Maintenance: Replacing the Light Bulb and Cooking Chamber Seal
A comprehensive guide for oven owners on how to safely replace the internal light bulb and the cooking chamber seal, including bulb specifications and safety advice.
Preview Oven Installation Dimensions and Cabinet Clearances
Technical diagram detailing the precise installation dimensions for a standard oven, including unit measurements and required cabinet clearances for proper fitting and ventilation.
Preview PEP25 and PDP25 Exploded View and Spare Parts List
Detailed exploded view and spare parts list for PEP25 and PDP25 ovens, including part numbers and descriptions for easy identification and ordering.
Preview Manual de Usuario: Horno Eléctrico Independiente
Manual de usuario completo para hornos eléctricos independientes de 50x55, 50x60 y 60x60. Incluye instrucciones de seguridad, uso, mantenimiento y solución de problemas.