ET80/ET85 Power/Vehicle/Office Dock Quick Start Guide

Cable Routing

Use the indicated cable tie slots for cable routing to prevent interference from the keyboard handle.

Diagram Description: The diagram illustrates cable management. It points out a port expander (labeled 1), the DC IN 12-14 VDC port (labeled 2), and cable tie slots (labeled 3) designed to keep cables tidy and away from moving parts.

Wall Mounting

Mount the ET80/ET85 Power Only or Vehicle docks on a wall using the following materials (not included with the dock):

• Rear standoffs: Minimum 6 mm (1/4 in.) thickness to allow the locking lever to fully open.
• Front washers: Minimum 15 mm (5/8 in.) outside diameter.
• Screws: #8 x 3 in. Phillips pan head wood screws.
• Hole pattern: Four 5.6 mm diameter holes spaced 100 mm x 100 mm apart.

Dock Compatibility

Use only with ET80 and ET85 tablets.

Power Only Dock

Model: CRD-ET8X-PWRDK1-01

• Provides tablet charging only.
• Includes: four 10-32 nuts, four screws, four washers, and two keys.
• Supports VESA mounting patterns: 100 mm x 100 mm, 100 mm x 50 mm, and 75 mm x 75 mm.
• Mount not included.

Vehicle Dock

Model: CRD-ET8X-VEHDK1-01

• Provides tablet charging, USB communication, and Ethernet communication.
• Includes: four 10-32 nuts, four screws, four washers, and two keys.
• Supports VESA mounting patterns: 100 mm x 100 mm, 100 mm x 50 mm, and 75 mm x 75 mm.
• Mount not included.

Office Dock

Model: CRD-ET8X-OFFDK1-01

• Provides tablet charging, USB communication, Ethernet communication, and HDMI ports.
• Includes: two keys and stand.

Operating Temperatures

Inserting the Tablet

Follow these steps to insert the tablet into the dock:

1. If previously installed, ensure the keyboard and handle are closed.
2. Insert the bottom of the tablet into the bottom of the dock (indicated as 1 in the diagram), aligning the charging contacts on the tablet with the connector pins on the dock.
3. Rotate the top of the tablet towards the top of the dock (indicated as 2 in the diagram).
4. Use your thumb to push the tablet fully into the dock, then push the lever down to secure the tablet.

Diagram Description: The diagram shows a step-by-step process for inserting a tablet into a dock. It highlights inserting the bottom first (1), then rotating the top (2), and finally securing it with a lever.