iScooter i12 Electric Scooter User Manual

Important Safety Information

Note to all riders under 14 years old: Parental permission is required before riding. This scooter is intended for riders aged 14 and above.

Before Riding:

• Always wear a helmet.
• Ensure the scooter has a full battery.
• Be aware of and follow local road laws.
• Do not ride under the influence of drugs or alcohol.
• Always respect pedestrians.
• Do not ride in wet conditions, as this can cause injury and damage the scooter's electronics, voiding the warranty.

Warning Message:

• Avoid water: The scooter is not waterproof. Water damage is not covered by warranty. Riding in wet conditions is dangerous.
• Abuse: Physical damage due to negligent care or extreme riding is not covered.
• Risk of Injury: Riding carries a risk of severe injury or death from loss of control, collisions, or falls. Ride with caution and at your own risk.
• Modifications: Do not modify the product from its original design.
• Moving Parts: Keep hands and body parts away from moving parts during operation.
• Pre-Ride Checks: Ensure the scooter is operating correctly, the braking system is functional, all safety labels are in place, and you understand the safety warnings. Check that axle guards, chain guards, and other protective covers are in place and in good condition. Verify tires are properly inflated with sufficient tread.
• Load Limit: Never exceed the maximum load rating of 264 lbs (120 kg).
• Age Restriction: The electric scooter should never be used by children under the age of 14.
• Maximum Speed: The maximum speed is 15 mph (25 km/h).

1. UNPACK

Your iScooter i12 box should contain:

• 1x Electric Scooter
• 1x Battery Charger
• 1x T Allen Wrench
• 1x Combination Wrench
• 1x Inner Tube

Remove all packaging material and inspect each item for any accidental shipping damage.

2. GET TO KNOW YOUR SCOOTER

Components:

• Handlebar: Includes Brake Lever, Handle Bar, Horn, Display, Light Switch, and Twist Throttle.
• Handle Post: Features a Folding Latch.
• Frame: Includes Headlight, Charger Port, Kickstand, Built-in Battery, Motor, and Tire.
• Other: Saddle and Carrier.

SPECIFICATIONS

* About the range: The range is measured under the conditions of a 154 lbs load, at a speed of 9 mph and 77°F.

3. ASSEMBLE YOUR SCOOTER

1. Unfold the handle post: Stand the handle post upright and close the locking latch.
2. Install the handlebar: Place the handlebar on the handlebar clamp slot. Tighten the clamp bolts. Open the handle post clamp's quick-release lever, adjust the handlebar to your desired height, and close the lever.
3. Install the saddle: Open the seat post clamp's quick-release lever, insert the seat post into the seat tube. Adjust the seat height and close the quick-release lever.
4. Install the rear basket: Align the bolt holes and tighten the 4 bolts to secure the rear basket.
5. Install the front wheel:
   • Find the front wheel.
   • Position the front fork onto the front wheel.
   • Hold the nut of the quick-release skewer with one hand and turn the quick-release lever clockwise with the other hand to tighten.
   • Close the quick-release lever.

4. CHARGE YOUR SCOOTER

Before using the scooter, fully charge the battery.

Charging Process:

1. Open the rubber charging port cover.
2. Insert the charging plug into the port.
3. The charger indicator light will turn from red (charging) to green (fully charged).
4. After charging, cover the charging port to protect it from dust and debris.
5. Charging Time: 5-6 hours.

Charging Requirement: Charge the scooter in conditions between 32°F and 104°F (0°C and 40°C).

5. SCOOTER FUNCTION MODE

1. Power On/Off: Turn the key to the right to turn the scooter on. Turn it in reverse to turn off the power.
2. Battery Level Display: The display shows 3 battery level bars when fully charged. Bars decrease as the battery level lowers. One bar indicates a low battery level requiring a charge.
3. Horn Use: Press the horn button to activate the horn.

RIDING TIPS

To start riding, sit on the saddle, place one foot on the deck, keep the other foot on the ground, press the accelerator, and the scooter will begin to move forward.

6. FOLD / UNFOLD YOUR SCOOTER

Ensure the scooter is powered off before folding.

• Folding: Power off the scooter. Push up the safety switch, open the folding latch, and fold the handle post.
• Unfolding: Stand the handle post upright and close the folding latch until it clicks. Ensure the folding latch is securely closed before each ride.

7. MAINTENANCE & REPAIR

Regular cleaning and maintenance will extend the life of your electric scooter.

Cleaning and Storage:

If the scooter is dirty, wipe it clean with a soft, damp cloth. Do not use alcohol, gasoline, kerosene, or other corrosive solvents, as they can damage the scooter's appearance and structure. Avoid using a pressure washer, as it may damage the electronics.

Adjusting Disc Brakes:

Check the front and rear disc brakes regularly for proper adjustment. A hex key (included) is required.

• If a disc brake is dragging, slide the clamp arm backward along the cable while holding the cable. Retighten the bolt on the brake clamp.
• If a disc brake is not working efficiently (slack cable), slide the clamp arm forward along the cable while holding the cable. Retighten the bolt on the brake cable clamp.

Notice: Disc brakes may squeak during initial use until they are broken in. This is normal and does not affect performance.

Tires:

If tire pressure is low, inflate to the recommended PSI (36 PSI) indicated on the tire's sidewall.

Storage:

When not in use, store the scooter in a dry, cool place. Avoid outdoor storage, as sun exposure can damage its appearance and wear down the battery and tires. Prolonged exposure to UV rays and rain may damage enclosed materials.

8. BATTERY INFORMATION

• Only use the approved power adapter for charging. Using other adapters may pose a fire risk or damage the equipment.
• Improper disposal of used batteries can pollute the environment. Comply with local disposal regulations.
• Store the scooter and power adapter in conditions between -4°F and 122°F (-20°C and 50°C).
• Warning - Risk of Fire: Contains no user-serviceable parts.

9. CONTACT US

For any issues related to riding, maintenance, safety, or errors with your iScooter i12 electric scooter, please contact iScooter customer service:

• Email: support@iscooterglobal.com
• Website: www.iscooterglobal.com
• Customer Service: Lifetime technical support available.

Thank you for your support!