Edifier X3 Lite True Wireless In-Ear Headphones

1. Power ON/OFF

Power ON: Earbuds power on automatically when taken out of the case. A white LED will be lit for 1 second.

Power OFF: Earbuds power off automatically when placed back in the case.

Note: If there is no Bluetooth connection for 10 minutes after powering on, the earbuds will power off automatically.

2. Pairing

1st Pairing:

• When earbuds are taken out of the case, white and red LEDs will blink alternately.
• Select "EDIFIER X3 Lite" in your Bluetooth device settings to connect.
• The white LED will blink twice in 5 seconds when successfully connected.

Note: For subsequent use, the earbuds will automatically connect to the device used last time.

3. Reset

1. Take the earbuds out of the case.
2. Ensure they are disconnected from any Bluetooth device. Press and hold the touch panel on either earbud for approximately 8 seconds until the red LED blinks 6 times. This clears the Bluetooth pairing records and powers off the earbuds. If the left and right earbuds are connected, the other side will also clear its Bluetooth pairing record and power off.
3. Place the earbuds back in the case and take them out again.
4. Select "EDIFIER X3 Lite" in your Bluetooth device settings to connect. The white LED will blink twice in 5 seconds when successfully connected.

4. Left & Right Connection

1. If there is no Bluetooth or TWS connection when the earbuds are powered on, tap the touch panel 5 times on both earbuds. The white LED will blink slowly, indicating TWS pairing mode.
2. Once the left and right earbuds are connected successfully, the white and red LEDs will blink alternately, entering Bluetooth pairing mode.
3. Select "EDIFIER X3 Lite" in your Bluetooth device settings to connect. The white LED will blink twice in 5 seconds when successfully connected.

5. Charging

Earbuds

• When a low battery prompt tone is heard, place the earbuds in the case for charging.
• The red LED on the earbud is steadily lit when charging and turns off when fully charged.

Charging Case

• Connect the case to a power source using the included Type-C charging cable.
• The red LED is steadily lit when charging and turns off when fully charged.

Note: Please do not charge the earbuds when there is sweat or other liquids inside the charging port, as this may damage the earbuds.

Input: 5V ⎓ 200mA (Earbuds), 5V ⎓ 1A (Charging Case)

6. Controls

Left Touch Panel

• 2s: Press and hold for 2 seconds to activate voice assistant.
• x2: Double tap to play/pause music or answer/end call.
• x3: Triple tap to switch to previous track.

Right Touch Panel

• 2s: Press and hold for 2 seconds to toggle noise cancellation (if applicable) or activate voice assistant.
• x2: Double tap to play/pause music or answer/end call.
• x3: Triple tap to switch to next track.

Note:

• Images are for illustrative purposes only and may differ from the actual product.
• Download the Edifier Connect App for more customizable control settings.

More Information

For more information, please visit our website: www.edifier.com

Follow us on social media:

• Facebook: @Edifierglobal
• Twitter: @Edifier_Global
• Instagram: @Edifier_Global