Nokia FastMile 5G Receiver: Safety and Regulatory Information
Safety Guidelines
Always read the Nokia FastMile 5G Receiver guides before setup or use of the product. It is your responsibility to familiarize yourself with the product reference guide, the online user guide and warnings, and to use a product properly.
Warning - Risk of electric shock or fire
Connect the product power adaptor or cord to the right supply voltage (for example, 220-240V AC in European countries, 120-240V in USA and Canada, etc.). Pay attention to the power load of the electrical outlet and possible extension cord. An overburdened power outlet or damaged cords and plugs may cause electric shock or fire. Check the power cords regularly. If you find any damage, replace the cord immediately. The socket-outlet shall be easily accessible.
Do not connect the plug into an extension cord, receptacle, or other outlet unless the plug can be fully inserted with no part of the blades exposed.
Leave adequate space for heat dissipation to avoid any damage caused by overheating the Product. Do not cover the Product or its ventilation holes. Blocking the ventilation holes may cause fire.
Do not exceed the operating temperature range: -40° C to +55°C / -40° F to +131° F (without Sun load).
Use the power adapter provided (PoE) with your Product. The use of any non-Nokia approved power supplies or power adapters is not supported or endorsed by Nokia. Such use will void any warranty or support contract with Nokia. Such use greatly increases the danger of damage to Product or property.
Do not fasten the power cable to building surfaces. Ensure the cable can move freely. Do not place heavy objects on the cable. Do not use the power adapter outside, and make sure all the connections are indoors or waterproof.
Do not install, use, or service this Product during a thunderstorm. There is a remote risk of electric shock from lightning. Make sure the pole is properly grounded when using the pole mount.
The standby power consumption of the Product is 4.2W. The maximum power consumption of the product is 5.9W.
Caution - Potential equipment damage
Follow these recommendations to protect yourself and the Product from harm:
- Do not insert any sharp object into the openings of a Product.
- The power adapter is for indoor use only. Do not put the power adapter in damp or wet locations; for example, near a bathtub, washbowl, kitchen sink or laundry tub, in a wet basement, or near a swimming pool. Do not spill any liquid on the power adapter.
- Do not touch the Product or its power adapter or cord with wet hands when power is on.
- Do not drop the device when mounting. Ensure that the place of mounting is not directly above an area where people/pedestrians will walk.
- Do not place the Product on an unstable surface or support. Ensure the device is securely attached to the surface to which it is mounted.
- Do not place anything on top of the Product.
- Do not paint the Product or its accessories.
- Do not use liquid or aerosol cleaners; unplug the Product and use a soft, dry cloth for cleaning.
- When connecting a PC or other electronic device to a Product, make sure you use the right cables and connect the device to the right port of the Product. Incorrect connections may damage the device and/or the Product.
- Do not open or try to open the Product. Opening or removing covers can expose you to dangerous high voltage points or other risks.
The Product contains components that emit an electromagnetic field and could interfere with pacemakers or other electronic medical devices. If you have a pacemaker or other implantable or personal medical device, please consult your physician or medical device manufacturer about the required minimum safe distance between the Product and your medical device.
If the Product malfunctions or fails to perform as expected, stop using it immediately.
Follow rules and regulations set forth prior to turning on the device in certain areas or environments (e.g., airports, hospitals, areas with flammables and explosives).
Environmental and Regulatory Requirements
Any changes or modifications not expressly approved by the party responsible for compliance of this Product voids the user's authority to operate this Product.
This Product complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This Product may not cause harmful interference
- This Product must accept any interference received, including interference that may cause undesired operation.
This Product has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This Product generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this Product does cause harmful interference to radio or television reception, which can be determined by turning the Product off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the Product and receiver.
- Connect the Product into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
For Products Purchased in the United States
FCC Radiation Exposure Statement
FC This device complies with FCC radiation exposure limits set forth for an uncontrolled environment. To ensure compliance with the FCC's RF exposure guidelines, the device must be used at least 10.6in / 27cm from your body.
The FCC reference ID is 2ADZR5G16B.
For further compliance information in this regard, including FCC Guidelines for Human Exposure and FCC Information for User, please consult your service provider or dealer where Product has purchased.
For Products Purchased in Canada
This device complies with Innovation, Science and Economic Development Canada license-exempt RSS standard(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
The IC ID is 21694-5G16B.
To satisfy IC RF exposure requirements, a separation distance of 11.8in / 30cm or more should be maintained between the antenna of this device and persons during device operation. To ensure compliance, operations at closer than this distance is not recommended.
Contact Information
The Products are imported by Nokia Of America. You can contact Nokia at the following addresses:
United States of America:
2301 Sugar Bush Road
Crabtree Overlook
Raleigh, North Carolina
27612-2956
Canada:
600 March Road
Ottawa, Ontario
Canada, K2K 2E6
You can also contact other Nokia office nearby you, see all addresses https://www.nokia.com/contact-us/offices/
The Products are manufactured by Nokia Solutions and Networks Oy.
© 2023 Nokia Solutions and Networks Oy
Karakaari 7, 02160 Espoo, Finland
Nokia is a registered trademark of Nokia Corporation
Nokia Corporation | Nokia
