Product Overview
This document provides instructions for the UNITEK 60W 10-Port USB Charging Station, model Y-2190D. It supports 10 USB-A ports with BC 1.2 charging, delivering up to 2.4A per port.
Package Contents
- 60W 10 Ports USB Charging Station
- DC 60W Power Adapter
- Separator Slats (5pcs tall + 6pcs short)
- User Manual
How to Install Separator Slats
The separator slats can be adjusted to fit your devices.
- Place the slat on the top of the station at the position that fits your device width.
- Align the slat to the slot.
- Push the slat until you hear a sound and it locks up.
Visual representation: Three steps indicated by ①, ②, ③ showing the placement, alignment, and locking of a separator slat.
Important Note
The UNITEK charging station will shut down automatically if power consumption exceeds 60W. In such cases, please unplug excessive devices and reconnect the power to resume charging.
Safety Notes
- Do not attempt to service or repair the product yourself. Leave any and all service work to qualified experts.
- Do not open the device or continue to operate it if it becomes damaged.
- Do not modify the product in any way. Doing so voids the warranty.
- Keep this product, like all electrical products, out of the reach of children!
Warranty Disclaimer
UNITEK assumes no liability and provides no warranty for damage resulting from improper installation/mounting, improper use of the product, or from failure to observe the operating instructions and/or safety notes.
Technical Data
- Power Input: DC 60W
- Power Output: 5V/2.4A (5V/2.4A charging can only be used on supported Apple devices)
- Total Power Output: 60W Max
Product Life Instructions
To prolong the product life, please follow the instructions below:
- DO NOT disassemble or modify this product.
- DO NOT expose it to water or fire to avoid short circuit or current leakage.
- DO NOT store this product in a humid or corrosive environment.
- DO NOT use it under high temperature conditions.
- DO NOT throw, trample, or hit the product.
- Remove it from the power source after operation or when it is not in use.
- Keep it out of children's reach.
- DO NOT insert objects other than appropriate cables.
- DO NOT use cables of doubtful quality for charging to avoid unnecessary accidents.
Service and Support
For further support information, please visit:
Email: support@unitek-products.com
Disposal Information
The [crossed-out trash can symbol] means that the equipment must not be disposed of with other waste. It should be disposed of in special containers according to the information prepared by the local government.