SunTouch | Radiant Floor Heating & Snow Melting Systems
User Manual for SunTouch models including: 500120 ConnectPlus Smart Sensor, 500120, ConnectPlus Smart Sensor, Smart Sensor, Sensor
SunTouch ConnectPlus Smart Sensor Floor Temperature and Water leak detector - 500120
File Info : application/pdf, 3 Pages, 588.72KB
DocumentDocumentInstallation and Operation Manual SunTouch® ConnectPlusTM Smart Sensor Description The ConnectPlusTM Smart Sensor is a temperature and water leakage sensor that pairs to the ConnectPlus thermostat. This device can be used as an optional floor temperature sensor for the radiant floor heating system. Detected water leaks produce audible and visual alarms, and notifications are transmitted to the thermostat. Where to Use Temperature Sensor Place the Smart Sensor directly on a heated section of the floor to use as a floor control sensor. Water Leakage Sensor Place the Smart Sensor directly on the floor where there is a risk of water leakage (near water lines, washing machines, hot water tanks, ...) within range of the ConnectPlus thermostat. Specifications · Power: 2 x AA batteries included · Battery Life : 1 year · Range: 75 ft, line-of-sight · Pairing limit: 6 devices · Operating Temperature range : 32°F to 104°F (0°C to 40°C) · Operating Humidity range : 0 to 100% humidity · Storage temperature range : -4°F to 122°F (-20°C to 50°C) · IP Waterproof Class : IP67 · Diameter 33/8" (85mm), Height 111/16" (43mm) ! WARNING Please read carefully before proceeding with installation. Your failure to follow any attached instructions or operating parameters may lead to the product's failure. Keep this Manual for future reference. Setup Wireless Pairing: · Put the ConnectPlus into pairing mode: Menu > Settings > Paired Devices > Pair Device · Press and hold button on the Smart Sensor for 3 seconds Wake: short button press Status Indicators: Not paired Orange blink Pairing Orange blink Paired Green steady Water Leak Red/Green blink & buzzer Error Red steady Low Battery Red blink Pairing Mode: hold the button down for 3 sec (30 sec timeout) Silence Buzzer: short button press Power 2 X AA Batteries Power Power 2 X AA Batteries 3 Screws Sensors ar on the bottom Sensors are located on the bottom Limited 3 Year Warranty SunTouch warrants this control (the product) to be free from defect in material and workmanship for a period of (3) years from the date of original purchase from authorized dealers. During this period, SunTouch will replace the product or refund the original cost of the product at SunTouch's option, without charge, if the product is proven defective in normal use. Please return the control to your distributor to begin the warranty process. This limited warranty does not cover shipping costs. Nor does it cover a product subjected to misuse or accidental damage. This warranty does not cover the cost of installation, diagnosis, removal or reinstallation, or any material costs or loss of use. This limited warranty is in lieu of all other warranties, obligations, or liabilities expressed or implied by the company. In no event shall SunTouch be liable for consequential or incidental damages resulting from installation of this product. Some states or provinces do not allow limitations on how long an implied warranty lasts, or the exclusion or limitation of incidental or consequential damages, so the above exclusions or limitations may not apply to you. This warranty gives you specific legal rights and you may also have other rights that vary from state to state. IOM-ST-ConnectPlus Smart Sensor 2202 81021009 USA: T: (888) 432-8932 · F: (417) 831-4067 · SunTouch.com Canada: T: (888) 208-8927 · F: (905) 481-2316 Latin America: T: (52) 55-4122-0138 · SunTouch.com © 2022 Watts Engineering Specification ES-ST-ConnectPlus Smart Sensor Job Name Job Location Engineer Approval Contractor Approval Contractor's P.O. No. Representative ConnectPlusTM Smart Sensor The ConnectPlusTM Smart Sensor is a temperature and water leakage sensor that pairs to the ConnectPlus thermostat. This device can be used as an optional floor temperature sensor for the radiant floor heating system. Detected water leaks produce audible and visual alarms, and notifications are transmitted to the thermostat. Specifications Literature Power Battery Life Operating Temperature Operating Humidity Range Storage Range IP Waterproof Case Dimensions IOM-ST-CPSS, ES-ST-CPSS 2 x AA Batteries Included 1 Year 32°F to 104°F (0°C to 40°C) 0 to 100% humidity -4°F to 122°F (-20°C to 50°C) IP67 Diameter 33/8" (85.38mm), Height 111/16" (42.87mm) ConnectPlus Smart Sensor 42,87 The ConnectPlus Smart Sensor is only compatible with the SunStat® ConnectPlus model. Does not connect to older model SunStat thermostats. Status Indicators: Not paired Pairing Paired Water Leak Error Low Battery Orange blink Green blink Green steady Red/Green blink & buzzer Red steady Red blink FCC ID: 2AFJT - CIMDOF18815 IC: 20938 - CIMDOF18815 ! CAUTION This Engineering Sheet is not intended to provide full installation instructions and safety information. In order to avoid property damage or injury, please refer to the complete installation manual and product safety information provided with the product. ø85,38 PRODUCT OPTIONS Qty Description ConnectPlus Smart Sensor Model# 500120 Order# 81020611 SunTouch product specifications in U.S. customary units and metric are approximate and are provided for reference only. For precise measurements, please contact SunTouch Technical Service. Suntouch reserves the right to change or modify product design, construction, specifications, or materials without prior notice and without incurring any obligation to make such changes and modifications on SunTouch products previously or subsequently sold. Refer to the owner's manual for warranty information. USA: T: (888) 432-8932 · F: (417) 831-4067 · SunTouch.com Canada: T: (888) 208-8927 · F: (905) 481-2316 Latin America: T: (52) 55-4122-0138 · SunTouch.com ES-ST-ConnectPlus Smart Sensor 2128 © 2021 Watts