Bluestone MCW7 Wireless Charging Gravity Lock Mount

Introduction

A mount that will charge your phone for you as you drive! Say no more! You found it! Using navigation can use a lot of battery from your phone. And if you're heading out somewhere, you're going to need that phone battery! Charge your phone while you use it to navigate in the car! No more having to decide one or the other, this is driving made simple, and navigating made even simpler.

Package Contents

• 1x Wireless Charging Mount
• 1x Air Vent Clip
• 1x Mount Suction Cup
• 1x Charging Cable

Product Overview

The Bluestone MCW7 is a wireless charging gravity lock mount designed for smartphones. It features a charger pad, gripping wings, supporting feet, a micro USB port for power, and a lever for adjustment. The mount can be attached to a car dashboard or vent using either a suction cup or an air vent clip.

Key Components:

• [charger pad]
• [wings]
• [feet]
• [micro port]
• [lever]

The product is shown installed in a car, holding a smartphone that is actively charging, indicated by a battery icon ? and "FAST CHARGE" text.

Specifications & Features

• Gravity Clamp with rubber grips
• Feet to support phone from falling
• Suction Cup for extreme security
• 360° rotating phone bracket
• ? Overheating Protection
• Easy Installation
• Vent Clip can easily fit into any vent system
• Compatible with wireless charging devices
• Power: 10 W Fast Charging
• Input: DC5V/2.0A, DC9V/1.67A
• Output: DC5V/1.0A, DC9V/1.2A

How to Use

Constructing the Mount

1. Unbox all pieces and make sure you have everything.
2. Take the mount head and line it up with the mount bracket and shove on.
3. Screw the joint part onto the back of the mount, but loosely.
4. Leaving it loose will allow the ball to pop in easily.
5. Once the ball is in the socket, tighten the knob and make sure it's tight.
6. This step applies to both the suction cup and air vent clip.
7. Place the mount on the dashboard or in the vent in your desired location.
8. Next, plug the USB part of the wire into your power source.
9. Plug the Micro B port into the mount head to power it up.
10. Place your phone up to the mount and push the wings out to make sure they extend far enough that your phone can fit.
11. Push down with your phone and push the feet down to make sure that the wings close tight on the phone.
12. The phone should immediately begin to charge. If not, make sure your case isn't too bulky, as that might be blocking the charging power of the mount.

Care and Safety

• Do not use this unit for anything other than its intended use.
• Keep the unit away from heat sources, direct sunlight, humidity, water, or any other liquid.
• Do not operate the unit if it has been wet or moist to prevent against electric shock and/or injury to yourself and damage to the unit.
• Do not use the unit if it has been dropped or damaged in any way.
• Repairs to electrical equipment should only be performed by a qualified electrician. Improper repairs may place the user at serious risk.
• Keep the unit out of reach of children.
• This unit is not a toy.