DIGITUS DA-70615 Safety Plug

Instruction Manual

Model: DA-70615

Package Content

• 1x Main unit
• 1x User Manual

Energy Efficiency

Input: 180-250V~, 50/60Hz, Max 0.25A

Output: 5.0V DC 2.8A, Max 14.0W

For Type A

• Average active efficiency: 82.5 %
• Efficiency at low load (10 %): 78.0 %

For Type C

• Average active efficiency: 81.2 %
• Efficiency at low load (10 %): 72.0 %

No-load power consumption: 0.09W

Connections & Installation

1. Turn power off before installation.
2. To connect the base as shown in Diagram A before installing into the mounting boxes, make sure there is no wire exposed at the connection. Note the phases cannot be ground trough to another safety wall outlet nearby. We recommend installing the safety outlet at the end of the row. (ATTENTION: the cross-sectional area of wire connect power is at least 1.5mm² not exceed 2.5mm²)
3. To fix the base by the screw or claw as Diagram B or Diagram C, then put the frame onto the base.

Diagram A Description:

Wiring diagram showing connections for Line (L), Neutral (N), and Earth (E) terminals.

Diagram B & C Description:

Illustrates the mounting process. The base unit is secured to the wall mounting box using screws (M3.5x20 for Diagram B, M3x10 for Diagram C). A frame is then attached over the base.

Important Notes

• DO NOT OVERLOAD.
• To install the product, a qualified electrician is needed.
• [Symbol description] The symbol in manual.

? For indoor use only

⚡ SMPS (switch mode power supply unit)

? SMPS incorporating a Short-circuit-proof safety isolating transformer (inherently or non-inherently)

⬜ Symbol for class II

? Protective earth

? Protective earth

Warning

For your safety, please read the following cautions before installing or using your device.

• Do not open the device or attempt to repair it.
• Use the device in a dry location, and avoid placing it in a humid environment.
• Do not submerge the device in liquid or attempt to clean it with liquids or solvents. To clean the device, disconnect it from the power outlet and use a damp towel.
• This device should only be used indoors.
• USB Charger Adaptor for IT-equipment: do not exceed the total max output from both USB outputs.
• Only use the device within the specified temperature range for: 0 ~ 40°C
• Do not let the indoor devices come into contact with liquids.
• During thunderstorms, there is a danger of lightning strike and due to overvoltage damage to connected electrical appliances.
• Do not install the product during a thunderstorm.
• Disconnect the product from power source during a thunderstorm.
• Keep the devices outside the reach of children, since these components can be dangerous.
• Never try to repair the device by yourself. Repair and maintenance work must be carried out by specialists.
• In case of problems, contact our customer service.
• Dust, humidity and vapours as well as sharp cleaning agents or solvents can damage the product.

Declaration of Conformity

Hereby Assmann Electronic GmbH, declares that the Declaration of Conformity is part of the shipping content. If the Declaration of Conformity is missing, you can request it by post under the below mentioned manufacturer address.

Manufacturer: Assmann Electronic GmbH

Address: Auf dem Schüffel 3, 58513 Lüdenscheid, Germany

Website: www.assmann.com

Certifications: CE [WEEE symbol]