Bestway Built-in Foot Pump Airbed Instruction Manual

Preparation

Unroll the airbed onto a flat area free from objects and debris. Ensure the flocked side faces up and the PVC side is on the ground.

Important Notes & Warnings

Please read these instructions carefully before using the airbed.

Warnings:

• Keep away from heat sources and fires.
• Avoid sharp and rough objects, as they can damage the airbed.
• Do not over-inflate or jump on the airbed, as this may decrease its lifespan.
• The airbed is not a life-saving device; do not use it in water.
• This product is exclusively designed for airbeds.
• Caution: There are risks when using the product outdoors and/or on watercraft.
• The airbed is not a toy; children should be supervised to ensure they do not play with the airbed or valve.

Notice: Read these instructions completely and save them for future reference.

Inflation

Built-in Foot Pump

Locate the foot pump and remove the white rubber plug from the suction port. Depress the foot pump area to inflate the bed. Ensure you press the pump straight down. Your foot should completely cover the suction port while depressing the pump to prevent air from escaping the inflation chamber. Lift your foot completely off the hole to allow the suction port to refill the chamber. Continue until the bed reaches proper firmness with most wrinkles gone. Reinsert the white rubber plug into the suction port and screw on the plastic cover. The airbed is now ready for use. [See Figure 1]

Air Pump

Open the valve; inflate the bed with an air pump and close the valve once inflated. [See Figure 2] Note: An air pump is not included.

After use, the airbed may require additional air to increase firmness. Add air to achieve your desired firmness.

Deflation

Open the valve to deflate the airbed. [See Figure 3]

Disposal

If the product is out of service, cut it and dispose of it according to your local council regulations. Dispose of the packaging carefully and thoughtfully. Do not litter. Be a good citizen and dispose of waste in an environmentally friendly manner.

Repairing

If the airbed surface is damaged, use the provided repair patch.

To repair:

1. Completely deflate the airbed.
2. Clean and dry the damaged area.
3. Apply a repair patch and smooth out any air bubbles.

Note: Never use other liquid glue or adhesive fabric; only use the provided repair patch.

Cleaning & Storage

If the airbed is dirty, use a clean, damp cloth and gently wipe down the surface. Ensure the airbed is dry before storing. Check the product for damage at the beginning of each season and at regular intervals during use.

Note: Do not use harsh detergents that may damage the airbed.

Once deflated, carefully fold the airbed and store it in a cool, dry location away from chemicals and heavy or sharp objects.