Uline H-185, H-186 Peanut Dispensers

Tools Needed

• Flat Head Screwdriver ?
• Pliers ?

Recommended Hardware (Not Included)

• Hook x 2 ?
• Cleat x 1 ⚓

Parts

Instructions

NOTE: Read instructions thoroughly. Remove all components from box and locate all parts. Remove pulley and U-bolt from rope.

Installing Pulleys

1. Attach pulleys to ceiling using hook or other secure method.
2. Make sure one pulley is positioned directly above the center of dispenser and the other clears the side of bag so rope will not interfere when raising and lowering bag. (See Figure 1)
3. Ensure rope tie-off method is in place (cleat, anchor, post, etc.). (See Figure 1)

Figure 1: Diagram showing two pulleys attached to the ceiling, with a rope running through them and a cleat for tie-off.

Installing Valve Assembly

1. Slide clamp ring over open side of tubing. (See Figure 2)
2. Insert valve assembly into bottom of flex tubing. Ensure tubing covers entire flange. (See Figure 2)
3. Turn yellow handles to desired position.
4. Slide clamp ring down around tubing, covering flange, and tighten screw with flat head screwdriver. (See Figure 2)

Figure 2: Close-up illustration of the valve assembly being inserted into the flex tubing and secured with a clamp ring.

Setting Up Canvas Bag

1. Locate two steel rods with tail ends.
2. Insert end of chain link into the loop of rod. (See Figure 3)
3. Repeat step two with the other chain links.
4. Insert one tail end through grommet at corner of canvas bag. Do not try to fit grommet into the loop. (See Figure 4)
5. Insert the other tail end through grommet on the opposite side of canvas bag.
6. Repeat step four and five with the second rod creating an "X" across the bag.
7. Locate U-bolt and remove the two nuts and plate from the bolt.
8. Place U-bolt over the center of rods "X" formation.
9. Re-insert plate then the two nuts on the U-bolt. Tighten nuts with pliers. (See Figure 5)
10. Thread rope through both pulleys.
11. Raise bag to desired height and tie off rope.

Figure 3: Illustration showing a chain link being inserted into the loop of a steel rod.

Figure 4: Diagram illustrating the insertion of a tail end through a canvas bag grommet.

Figure 5: Close-up of the U-bolt, plate, and nuts being assembled over the steel rods.