Hoover Power Scrub XL Carpet Cleaner

Important Safety Instructions

Save These Instructions

Read All Safety Warnings and Instructions Before Using This Product.

WARNING: When using an electrical product, basic precautions should always be followed to avoid electric shock, fire, and/or serious injury, including:

• Fully assemble product prior to use.
• Operate cleaner only at voltage specified on the data plate on the lower back of the cleaner.
• Do not leave appliance plugged in. Unplug when not in use and before cleaning or servicing.
• Use indoors only. Do not immerse. Use only on surfaces moistened by the cleaning process.
• To Reduce the Risk of Fire and Electric Shock due to internal component damage, use only Hoover® Cleaning Fluids intended for this appliance.
• Do not allow to be used as a toy. Not intended for use by children age 12 and under. Close supervision is necessary when used by or near children. Keep children away from product and do not allow them to place fingers or other objects into any openings.
• Use only as described in this manual. Use only HOOVER® recommended attachments.
• Do not use product with a damaged cord or plug. If product is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, call customer service at 1-800-944-9200 before continuing use.
• Do not pull or carry by cord, use cord as a handle, close a door on cord, or pull cord around sharp edges or corners. Do not place product on cord. Do not run appliance over cord. Keep cord away from heated surfaces.
• Do not unplug by pulling on cord. Grasp the plug, not the cord.
• Do not handle plug or appliance with wet hands.
• Do not put any object into openings. Keep openings free of dust, lint, hair, and anything that may reduce air flow.
• Keep hair, loose clothing, fingers, and all parts of body away from openings and moving parts.
• Turn off all controls before unplugging.
• Use extra care when cleaning on stairs. Always place cleaner at the bottom of stairs or on the floor to avoid personal injury or damage, and to prevent the cleaner from falling. Do not place cleaner on stairs or furniture.
• Do not use to pick up flammable or combustible liquids, such as gasoline, or fine wood sandings, or use in areas where they may be present.
• Connect to a properly grounded outlet only. See Grounding Instructions.
• Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes.
• Do not use without filters and tanks in place.
• Do not clean over floor electrical outlets.

CAUTION: TO REDUCE THE RISK OF DAMAGE:

• Avoid picking up hard, sharp objects, as they may cause damage.
• Store appropriately indoors in a dry place. Do not expose machine to freezing temperatures.
• Do not use sharp objects to clean out the hose, as they can cause damage.
• To assist in reducing drying time, ensure the area is well ventilated when using detergents and other cleaners.
• To help prevent matting and resoiling, avoid contact with carpets until they are dry. Keep children and pets away from carpets until they are completely dry.
• Do not store the extractor with solution in tanks.
• With brushes on, do not allow the cleaner to sit in one location for an extended period, as damage to the floor can result.
• Do not use this extractor on hard floors, as it may scratch or damage your floor.

Note: Water will drip from the brushes and underside of the product after use and may puddle. To avoid damage to wood and laminate flooring and to avoid potential slip hazard, after use, do not leave the product on wood and laminate surfaces; remove it to a hard surface and place it on absorbent material (such as a towel) to soak up drips.

Grounding Instructions

This appliance must be grounded. If it malfunctions or breaks down, grounding provides a path of least resistance for electric current to reduce the risk of electric shock. The appliance is equipped with a cord having an equipment-grounding conductor (C) and a grounding plug (A). The plug must be inserted into an appropriate outlet (B) that is properly installed and grounded in accordance with all local codes and ordinances.

WARNING: Improper connection of the equipment-grounding conductor can result in the risk of electric shock. Check with a qualified electrician or service person if you are in doubt as to whether the outlet is properly grounded. Do not modify the plug provided with the appliance; if it will not fit the outlet, have a proper outlet installed by a qualified electrician. This appliance is for use on a nominal 120-volt circuit and has a grounding plug that looks like plug (A) illustrated in Fig. 1. A temporary adapter (D) may be used to connect this plug to a 2-pole receptacle (E) if a properly grounded outlet is not available (Fig. 2). The temporary adapter should be used only until a properly grounded outlet (B) can be installed by a qualified electrician (Fig. 1). The green colored rigid ear, lug, or the like (F) extending from the adapter must be connected to a permanent ground (G) such as a properly grounded outlet box cover (Fig. 2). Whenever the adapter is used, it must be held in place by a metal screw. NOTE: In Canada, the use of a temporary adapter is not permitted by the Canadian Electrical Code.

Diagram Description: Figure 1 shows a standard grounded plug (A) connecting to a grounded outlet (B). Figure 2 illustrates the use of a temporary adapter (D) connecting a plug (A) to a 2-pole receptacle (E), with the adapter's ground lug (F) connected to a permanent ground (G).

Warranty

Limited Warranty for Hoover® Product / Two Year Limited Warranty (Domestic Use)

If this product is not as warranted, contact TTI Floor Care North America Customer Service at 1-800-944-9200. Please have proof of purchase and model number available.

What This Warranty Covers: This limited warranty provided by Royal Appliance Mfg. Co., doing business as TTI Floor Care North America (“Warrantor”), applies only to products purchased in the U.S. (including territories and possessions), a U.S. Military Exchange, or Canada. When used and maintained in normal household use and in accordance with the Owner’s Guide, this product is warranted against original defects in material and workmanship for TWO years from the date of original purchase (the “Warranty Period”). Warrantor will, at its sole discretion and free of charge (subject to shipping costs), either repair, ship a replacement product (subject to availability), or ship a similar product of equal or greater value if parts or replacements are not reasonably available.

Who This Limited Warranty Covers: This limited warranty extends only to the original retail purchaser with original proof of purchase from Warrantor or an authorized dealer in the U.S., U.S. Military Exchanges, and Canada.

What This Warranty Does Not Cover: This warranty does not cover commercial operation, improper maintenance, misuse, negligence, neglect, vandalism, use of incorrect voltages, damage from acts of God, accidents, owner’s acts or omissions, service by unauthorized providers, use outside the country of purchase, resale, pick-up/delivery/transportation/house calls, products that have been altered or modified, or repairs made necessary by normal wear or use of incompatible parts or accessories. Normal wear items (belts, filters, brush rolls, etc.) are not covered.

Other Important Terms: This warranty is not transferable. It shall be governed by the laws of North Carolina. The Warranty Period will not be extended by any replacement or repair.

Disclaimers: THIS LIMITED WARRANTY IS THE EXCLUSIVE WARRANTY AND REMEDY. ALL OTHER EXPRESS AND IMPLIED WARRANTIES, INCLUDING WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE EXPRESSLY DISCLAIMED. Warrantor shall not be liable for any special, indirect, incidental, or consequential damages of any kind or nature, even if this warranty fails of its essential purpose.

State Variations: Some states do not allow exclusions or limitations on incidental or consequential damages, or limitations on implied warranties, so the above exclusions may not apply to you. This warranty gives you specific legal rights, and you may also have other rights that vary from state to state.

Genuine Parts and Accessories: Use only genuine HOOVER® solutions, parts, and accessories. Damage caused by non-genuine items is not covered and may void your warranty.

Getting Started

Assembly

1. Insert the handle into the base.
2. Align the groove on the backside of the clean water tank with the handle and drop straight down.

Quick Clean Mode

1. To engage Quick Clean Mode, turn the knob counterclockwise until engaged.
2. Return to Deep Clean mode by turning the knob clockwise.

How to Use

1. Plug the cord into an electrical outlet.
2. Turn the unit ON/OFF with the side pedal.
3. Recline the unit with the middle pedal.
4. Squeeze the trigger to apply water and cleaning solution.
5. Slowly push forward with the trigger pressed to wash, then slowly pull backward with the trigger released to dry.

Notes: For best results, vacuum carpet and upholstery thoroughly with a HOOVER® vacuum before use. For best results, rinse the carpet after deep cleaning with clean water only to remove residual cleaning solution. To rinse, remove the solution tank and repeat steps 4 and 5.

Operation

CAUTION: DO NOT USE THIS EXTRACTOR ON HARD FLOORS. USING THIS PRODUCT ON HARD FLOORS MAY SCRATCH OR DAMAGE YOUR FLOOR.

CAUTION: Use extra care when cleaning on stairs. To avoid personal injury or damage, and to prevent the cleaner from falling, always place the cleaner at the bottom of stairs or on the floor. Do not place cleaner on stairs or furniture, as it may result in injury or damage.

Fill the Clean Water Tank

1. Lift up to remove the Clean Water Tank, then remove the cap and add warm water to the fill line. Add 3oz. of Hoover Solution. Secure cap.
2. Align the tank and firmly press it into place.

Empty the Recovery Tank

Note: To maintain proper suction, empty the Tank when the Red Bobber is visible.

1. Turn the cleaner off and unplug from the electrical outlet.
2. Grab the Recovery Water Tank handle and lift up and outward to remove it. A second handle is provided on the back of the Recovery tank for carrying.
3. Unlatch the tank lid and empty it. Rinse and allow to air dry.

Using the Hose

CAUTION: Always turn off the appliance before connecting or disconnecting the hose.

CAUTION: Not to be used for grooming a pet.

1. Attach hose by opening the Hose Connection Port on the nozzle.
2. Hold open the Hose Solution Port door. Plug the Hose Solution Tube connector firmly into the Hose Solution Port.
3. To drain the hose, run the unit and do not press the spray button on the hose/tool end.

Note: The hose port door is spring loaded to close automatically. Ensure the Hose Port Door is fully shut for the best performance. To ensure maximum performance and to protect your carpet, place the handle in the upright position while using the hose.

Removing the Hose

1. Turn the cleaner off and unplug from the electrical outlet.
2. Press the button and firmly pull up to remove the Hose Solution Tube from the Solution Port.

How to Use Tools

CAUTION: To reduce the risk of injury from moving parts - Unplug before connecting SpinScrub® Hand Tool. Not to be used for grooming pets.

1. Place the handle in the upright position. This will shut off the SpinScrub® brushes.
2. Connect the tool to the hose by sliding it onto the connector until it locks into place.
3. Using your thumb, push forward and up on the latch to remove the tool. Note: The Antimicrobial pet tool included with select models only has a button to release the tool from the hose.
4. Pre-spray the carpeted stair by holding the tool about one inch above the carpet and push it forward while pressing the trigger.
5. Position the tool against the riser and slightly press it into the carpet pile. Press the trigger and pull the tool slowly over the carpet. Release trigger at the end of the stroke.
6. Lift the tool, and position it against the riser. Pull the tool slowly over the carpet without pressing the trigger. Note: Overlap strokes by 1/2 inch to help prevent streaking.

Nozzle Care

1. First, turn off and unplug the carpet cleaner. Remove the Recovery Tank.
2. Pull up on the Nozzle slightly to unsnap, then pull the Nozzle forward to remove it from the carpet cleaner. Rinse with water and allow to air dry.
3. Push the latches out on the side of the foot until they lock open.
4. Snap the Nozzle to the foot and rotate the latch into the lock position. IMPORTANT: The nozzle must be in the proper position for the Dirty Water Tank to go on properly and for the unit to have proper suction.

Brush Care

1. Remove the tanks and place the handle in the upright position. Tilt the cleaner back until the handle rests on the floor.
2. Push the latches out on the side of the foot until they lock open.
3. The Brush assembly should be free to pull out.
4. Rinse the brushes under running water.
5. Replace them by aligning the center drive post and noting the arrows indicating the front of the machine. Push firmly until the latches lock into place.

Maintenance

Lubrication: The motor is equipped with bearings which contain sufficient lubrication for their lifetime. The addition of lubricant could cause damage. Do not add lubricant to motor bearings.

Cord Storage: Wrap the power cord around the cord hooks for convenient storage. Attach the plug end to the cord.

Troubleshooting

WARNING: To reduce the risk of personal injury, unplug before cleaning or servicing.

CAUTION: To reduce the risk of injury from moving parts - Unplug before servicing. Do not use cleaner without brushes in place.

This product contains no serviceable parts. If the appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, call customer service at 1-800-944-9200 prior to continuing use.