Hiko Ceiling Pendant User Guide

Caring for your product

We recommend cleaning with a soft, dry cloth. Do not use abrasive cleaning materials as these will damage the finish.

Indoor use only.

Replace bulbs from John Lewis or established brand of the same type and compatibility.

Aftercare and Troubleshooting

If you experience any unresolvable technical issues with the product, contact your nearest John Lewis & Partners shop or John Lewis & Partner Technical Support on 03301 230106.

Specification

Max. power: 5W Max LED

Rated input: 240V, 50Hz

IP rating: 20

Weight: 4.6 kg

UK ™

5 years guarantee

At John Lewis & Partners we test every light to high quality standards so we are able to offer you a 5 years guarantee.

Recycling

This symbol ♻️ indicates that this product should not be treated as normal household waste and it should be recycled. John Lewis & Partners do not operate instore take back, but as members of the Distributor Take Back scheme have funded the development and upgrade of recycling facilities across the UK. Please take it to your nearest collection facility or for further details contact your local council or visit www.recycle-more.co.uk.

Product assembly

1. Fix the metal bracket to the ceiling, ensuring there is a joist at the point of fixing to support the weight of the product.

   Mark in the ceiling the position of the bracket holes. Drill in these points ensuring any wire of the existing household wiring could be damaged. Insert the wall plugs, place the bracket over them and screw up the bolts.

2. Having identified the household wiring from your existing light fitting, connect to the connection block inside.

   Ensure that:

   • You have correctly identified the house wires.
   • The connections are tight. No loose strands have been left out of the connection block.

3. If necessary, loosen the small piece D-c and move the cable D-b to adjust the height of the pendant lamp. Then tighten the piece D-c again.

4. Embed the threaded rod.

5. Tighten the upper nut.

6. Pull down cap D-d onto rod.

Parts list

Warnings

This product is Class II.

For your safety, this product must be installed in accordance with local Building Regulations.

If in any doubt, or where required by the law, consult a competent person who is registered with an electrical self-certification scheme. Further information is available online or from your Local Authority.

To prevent electrocution, switch off at the mains supply before installing or maintaining this fitting. Ensure other persons cannot restore the electricity supply without your knowledge.

Always use the correct type and rated power bulb. Never exceed the rated power stated.

When changing a bulb, always switch off at the mains and allow the old bulb to cool down before handling. Dispose of used bulbs carefully.

The bulb and surrounding parts can become extremely hot during use.