Hohem HRT-O3 All-in-one Remote Control

Specifications

Pairing the Remote Control with the Gimbal

Ensure the gimbal is powered on. Press the gimbal's function button 7 times. The Bluetooth light will flash alternately in yellow and green, indicating it has entered pairing mode.

Important: Make sure the gimbal is in pairing mode before turning on the remote control to connect.

During the Pairing Process:

• Pairing is typically completed within 3 seconds after the gimbal's Bluetooth light stops flashing alternately in yellow and green.
• If pairing is not completed within 30 seconds, it will be cancelled.
• Press the function button once to cancel pairing.
• Double-press the function button to clear paired remote controls and cancel pairing. (A cleared remote control will be unavailable and require re-pairing).

Button Functions:

1. Power Button: ON / OFF
2. Shutter Button: (Requires successful app connection to the gimbal)
   • Single Press: Take photo, Start/End video
   • Double Press: Switch between photo and video modes
   • Triple Press: Switch front and rear cameras (Functionality depends on the app)
3. Function Button:
   • Single Press: Switch between landscape and portrait modes
   • Double Press: Recenter the gimbal
   • Triple Press: Activate Inception mode (auto-rotation)
4. M Button (Gimbal Working Mode):
   • Single Press: Pan&Tilt Follow
   • Double Press: Pan Follow
   • Triple Press: All Lock
   • Quartic Press: POV (All Follow)
   • Long Press: Switch between zoom in/out mode and gimbal tilt control mode (Zoom functionality is app-dependent)
5. Navigation Buttons (Up/Down/Left/Right):
   • Up/Down: Controls gimbal tilt. Indicator light shows green.
   • Up/Down (with app): Controls image zoom in/out. Indicator light shows blue.
   • Left/Right: Controls gimbal pan.
6. Indicator Light: The indicator light shows green or blue during button operations. If no light is displayed, the remote control is either not powered on or has no battery.
   • Green light: Indicates gimbal control.
   • Blue light: Indicates phone camera control.

FCC Statement

Federal Communication Commission (FCC) Radiation Exposure Statement: The device has been evaluated to meet general radio frequency (RF) exposure requirements and can be used in portable exposure conditions without restriction.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.

NOTE: Hohem Technology Co., Ltd. is not responsible for any radio or TV interference caused by unauthorized modifications or changes to this equipment. Such modifications or changes could void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

FCC ID: 2AIB7RT