Avantco Refrigeration Operation Instructions

Series: 193BC, 193BCT, 193CAC, 193HAC, 193MAC, 193VAC, 193VOA, 360BCC, 360BCDI, 360BCS, 360BCSS, 360CRR, 360GSM, 360RSD

How to Reset the Temperature Range

1. Press the down arrow button [▽] for 10 seconds until the display shows "ON." This means the controller is open for adjusting all parameters.

   [Display shows "ON" with temperature and set point indicators]

2. Press "SET" for 6 seconds until the display flashes "E1."

   [Display shows "E1" with temperature and set point indicators]

3. Press the down arrow button [▽] until you reach 32°F.

   [Display shows "32" with temperature and set point indicators]

4. Do not touch the controller for 10 seconds. This will save the settings.

   [Display shows "32" with temperature and set point indicators]

5. Press the down arrow button [▽] for 10 seconds until the display shows "OFF." This will lock your settings in place.

   [Display shows "OFF" with temperature and set point indicators]

6. Press "SET" again. The display will flash the temperature at which the compressor currently cycles off. The compressor will kick on approximately 7-8 degrees above this set point.

   [Display shows "32" with temperature and set point indicators]