Avantco Refrigeration
Operation Instructions
Date: 07/2025
Series: 193BC, 193BCT, 193CAC, 193HAC, 193MAC, 193VAC, 193VOA, 360BCC, 360BCDI, 360BCS, 360BCSS, 360CRR, 360GSM, 360RSD
How to Reset the Temperature Range
-
Press the [Up Arrow Button] for 10 seconds until the display shows "ON." This indicates the controller is ready for parameter adjustment.
Visual: Controller display shows "ON". An arrow points to the [Up Arrow Button].
-
Press the [SET Button] for 6 seconds until the display flashes "E1."
Visual: Controller display shows "E1". An arrow points to the [SET Button].
-
Press the [Down Arrow Button] until you reach 32°F.
Visual: Controller display shows "32". An arrow points to the [Down Arrow Button].
-
Do not touch the controller for 10 seconds. This action saves the current settings.
Visual: Controller display shows "32". No specific button is indicated.
-
Press the [Up Arrow Button] for 10 seconds until the display shows "OFF." This action locks your settings in place.
Visual: Controller display shows "OFF". An arrow points to the [Up Arrow Button].
-
Press the [SET Button] again. The display will flash the temperature at which the compressor currently cycles off. The compressor will typically activate approximately 7-8 degrees above this set point.
Visual: Controller display shows "32". An arrow points to the [SET Button].