Myco ON LED Luminaire

Mounting Holes

Diagram showing dimensions for mounting holes.

Dimensions provided: 5.5, 12, 23, 26.

Electrical Wiring Diagrams

The following diagrams illustrate the electrical connections for different control types.

ON/OFF Control (Model: 31.61XX.9XX.XXX)

Connects to a LED Power Supply. Requires a 230V, 50Hz power source. Connections are made to N (Neutral) and L (Live) terminals.

TRIAC Control (Model: 31.61XX.DXX.XXX)

Connects to a LED Power Supply with TRIAC dimming capabilities. Requires a 230V, 50Hz power source. Connections are made to N (Neutral) and L (Live) terminals. Includes an [RC component] for dimming control.

DALI Control (Model: 31.61XX.E/BXX.XXX)

Connects to a LED Power Supply using the DALI protocol. Requires a 230V, 50Hz power source. Connections are made to D- (DALI negative), D+ (DALI positive), N (Neutral), and L (Live) terminals.

Assembly Instructions

1. Step 1: Turn off the power. (Symbol: ⚡️ OFF)
2. Step 2: Attach the mounting bracket to the ceiling using screws (A) and dowels. Refer to the mounting holes scheme for placement.
3. Step 3: Connect the 230V power to the driver. Ensure the fixture is properly grounded. Refer to the electrical wiring diagrams for specific connections.
4. Step 4: Mount the lamp body to the mounting bracket by tightening the screws (B).
5. Step 5: Turn on the power. (Symbol: ⚡️ ON)

Tools and Mounting Surface Guidance

The enclosed tool kit is designed for use with solid materials such as solid brick, wood, concrete, and aerated concrete, as well as gypsum board surfaces. It is crucial to select and use the appropriate dowel for the specific mounting surface. Correct dowel usage ensures the safety and structural integrity of the installation.

Included Tools:

• 2x Allen Key
• 2x Allen Key
• 1x Allen Key

Diagram shows the lamp body being attached to the mounting bracket with screws labeled 'B'.