BaBylissPRO FOILFX02 Cord/Cordless Metal Double Foil Shaver

Important Safety Instructions

Read all instructions before using. Keep away from water.

DANGER

Any appliance is electrically live, even when the switch is off. To reduce the risk of death or injury by electric shock:

• Always unplug appliance from electrical outlet immediately after using (except when charging unit).
• Do not place or store appliance where it could fall or be pulled into a tub or sink.
• Do not use appliance while bathing or in the shower.
• Do not place appliance in, or drop into water or other liquids.
• If appliance has fallen into water, do not reach for it. Unplug immediately.
• Unplug this appliance before cleaning.

WARNING

To reduce the risk of burns, electric shock, fire, or injury to persons:

• Never leave a plugged-in appliance unattended.
• Close supervision is required when this appliance is used by, on, or near children, or persons with limited physical, sensory, or mental capabilities or invalids.
• Use appliance only for its intended use as described in this manual. Use only attachments recommended by the manufacturer. Do not use an extension cord to operate the appliance.
• Never operate the appliance if it has a damaged cord or plug, is not working properly, has been dropped or damaged, or dropped into water. Return the appliance to a BaBylissPRO Service Center for examination and repair.
• Keep the appliance cord away from heated surfaces.
• Do not pull, twist or wrap the cord around the appliance.
• Never drop or insert any object into any opening on the appliance.
• Do not place the appliance on any surface while it is operating.
• Do not use this appliance with a damaged or broken foil or cutter, as injury to skin may occur.
• Do not use the appliance outdoors or where aerosol (spray) products are being used or where oxygen is being administered.
• Do not crush, or heat above 212° F (100° C) or incinerate the appliance, due to risk of fire, explosion or burns.
• Always attach plug to appliance first, then to outlet. To disconnect, turn all controls to OFF (O) position then remove from outlet.
• For the purpose of recharging the battery, only use the detachable supply unit provided with this appliance.

CAUTION

• DO NOT run shaver or cutters under water. Use only the small brush (included) to clean.
• To clean the external surfaces of the shaver, use a damp cloth. Do not use strong detergents or other chemicals.
• To dry, wipe the surface of the shaver with a dry towel. Do not use a hair dryer or heater to dry the shaver.
• The shaver should not be used until it has completely dried.
• Be sure voltage is correct before plugging in. For connection to power supply not in the U.S.A. use an attachment plug adapter of the proper configuration for power outlet. The included adapter automatically adjusts to the input voltage. DO NOT USE A VOLTAGE CONVERTER.

Operating Instructions

Charging

1. Before using the shaver for the first time, charge continuously for 3 hours. Maximum battery capacity will only be reached after 3 charging and discharging cycles.
2. Make sure the switch on the shaver is in the OFF (O) position. Connect the charging jack into the receptacle on the bottom of the shaver. Plug the adapter into any electrical outlet (at the voltage listed on the label affixed to the adaptor). The charging indicator will light up to indicate that the charging has begun. Charging is complete after 3 hours.
3. The adapter may become warm while charging. This is normal.

Preserving the Batteries

In order to maintain the optimum capacity of the rechargeable batteries, the shaver should be recharged for 3 hours approximately every 6 months.

Direct Plug-in Operation

Make sure shaver is off. Connect charging jack into the receptacle at the bottom of shaver and plug the adapter into power outlet.

ON/OFF Switch

To operate, simply slide switch to the ON (I) position. To stop operation, set to the OFF (O) position.

Basic Instructions for Use

1. Men whose skin is sensitive or easily irritated by shaving, or who suffer from a skin allergy, should test one section on the leg or arm before using the shaver.
2. Remove the protective cover and turn on the unit to start shaving. Hold the shaver at a right angle to the area that you want to shave and run the double shaving foil carefully along your skin.
3. Tip: In general, we recommend that you shave against the direction of hair growth, as this is the best way to trim the hair. Pull your skin tight, with your fingers in inaccessible areas, to achieve optimum results.
4. Switch the shaver off each time after shaving and clean it.
5. Do not push the shaver on the skin too hard as it could cause irritation, make the shaver warm and prevent a perfect shave.
6. Please note that it takes 2 to 4 weeks for your skin to adapt to a shaver, so please do not change shaving instruments in this period of time.
7. If hair is longer than 1/32" begin by cutting the hair down first with a trimmer, than use shaver for a smooth close shave.

User Maintenance Instructions

Taking Care of Your Shaver

Do not remove the shaving foil unit while the shaver is switched on. Always switch the shaver off! Ensure that no water gets into the inside of the shaver to avoid the risk of an electric shock when it is back in operation. Never press on the cutting blades or the shaving foil and do not touch them with hard objects as this can cause irreparable damage to the shaver or parts. Be careful when dealing with the blades, as they are very sharp. Risk of injury! When cleaning, do not apply any detergents or scouring agents and do not use any abrasive or sharp objects. They can cause irreparable damage to the shaver.

Cleaning

NOTE: When cleaning your shaver, make sure the unit is turned off.

• Use the small brush (included) to clean cutters.
• To clean the external surfaces, use a damp cloth. Do not use strong detergents or other chemicals.
• Dry the surface with a dry towel. Do not use a hair dryer or heater.
• Ensure the shaver is completely dry before use.

To Replace Foil Head Assembly

1. Remove the foil head assembly by pressing the round release button located on the side of the shaver. Hold the foil head assembly on both sides and lightly pull away from shaver unit.
2. Take the replacement foil head assembly (FXRF2/FXRF2G/FXRF2RG) out of package. Align the replacement foil head assembly over the cutters. Carefully move the replacement foil head assembly down towards the shaver unit until it firmly snaps into place. BE CAREFUL NOT TO DAMAGE THE FOILS OR CUTTERS WHILE INSTALLING.

To Replace Cutters

NOTE: Always replace the cutters and foil head assembly at the same time.

1. To remove cutters, place your fingers on each side and gently pull up and away from drive shaft.
2. To replace cutters, remove the new cutters (FXRF2/FXRF2G/FXRF2RG) from the packaging. Align cutter about the drive shaft and lightly push down until it snaps into place.
3. Replace the foil head assembly, turn shaver on to ensure it is working properly.

Daily Maintenance

1. Press the release button on the sides of shaver and remove the head assembly.
2. Use cleaning brush to whisk away any debris on and around cutter.
3. Snap the head assembly closed.

Weekly Maintenance

1. Repeat steps 1-3 from the Daily Maintenance cleaning steps.
2. Rinse the head of the shaver under running water. NEVER submerge the shaver in water.
3. Leave head open for drying.
4. Press the shaver head back into place.

Battery Removal

When your rechargeable shaver reaches the end of its useful life, the Ni-MH batteries must be removed from the shaver and be recycled or disposed of properly in accordance with your state and local requirements. If not required by law, you may elect to dispose of the shaver with the batteries.

To remove the rechargeable battery:

1. Unplug the shaver.
2. Run shaver until motor stops.
3. Remove foil head from shaver (press release button and pull head away from shaver body).
4. Remove screw from bottom housing. Remove 2 screws from metal plate under cutters.
5. Remove cutters by pulling away from drive shafts.
6. Remove on/off switch and release button by lightly prying free with a small screwdriver.
7. Slide off metal cover.
8. Remove screws holding inner plastic casing together.
9. Pry batteries free from circuit board and cut wires.
10. Dispose batteries.

Contains Nickel Metal Hydride battery. Must be collected, recycled or disposed of properly. Do not dispose of in municipal waste. Do not put in fire or mutilate, as the battery may burst or release toxic materials. Do not short-circuit, as this may cause burns.

Parts Identification

• Protective Cover
• Adapter
• Shaving Foil
• Release Button
• ON/OFF Switch (ON: "I", OFF: "O")
• Cleaning Brush
• Charging Socket
• LED Charging Indicator

Warranty Information

Limited 2-Year Warranty (U.S. and Canada Only)

BaBylissPro will repair or replace (at its option) your unit free of charge for 24 months from the date of purchase if the appliance is defective in workmanship or materials. To obtain service under this warranty, return the defective product to the service center listed below, together with your purchase receipt and $15.00 for postage and handling. California residents need only provide proof of purchase and should call 1-800-326-6247 for shipping instructions. In the absence of a purchase receipt, the warranty period shall be 24 months from the date of manufacture. Any implied warranties, obligations, or liabilities, including but not limited to the implied warranty of merchantability and fitness for a particular purpose, shall be limited in duration to the 24-month duration of this written, limited warranty. Some states do not allow limitations on how long an implied warranty lasts, so the above limitations may not apply to you. BaBylissPro shall not be liable for any special, incidental, or consequential damages for breach of this or any other warranty, expressed or implied, whatsoever. Some states do not allow the exclusion or limitation of special, incidental, or consequential damages, so the above limitation may not apply to you. This warranty gives you specific legal rights, and you may also have other rights, which vary from state to state.

Service Center:
BabylissPro Service Department
7475 N. Glen Harbor Blvd.
Glendale, AZ 85307
1-800-326-6247

Canadian Two Year Replacement Warranty

Dannyco Professional is the exclusive Canadian distributor of this product. This warranty is not valid in case of abuse, misuse, alterations or repairs done by unauthorized persons. Before returning your defective electrical product, please read the warranty conditions listed in this brochure. Should your professional electrical appliance possess a manufacturer's defect, it may be exchanged by your distributor or Dannyco Professional at no charge within TWO YEARS from date of purchase, if the electrical appliance is accompanied by a proof of purchase.

If sending your defective appliance directly to the Dannyco Professional Service Center, it must be accompanied by:

1. Your dated sales slip.
2. A precise description of the defect.
3. Your complete return address and daytime phone number.
4. A $10 money order for postage and handling.

Please return your defective appliance to:
ATTN: Dannyco Professional Service Center
CONAIR CONSUMER PRODUCTS ULC
100 Conair Parkway
Woodbridge, Ontario L4H 0L2

This warranty applies only to residents of Canada. Products shipped from outside of Canada will not be processed and will not be returned to sender. For questions regarding this product, you may call Dannyco Professional's Service Centre at: 1-800-363-0707, or email customerservice@dannyco.com.