Introduction
This guide provides essential information for the quick installation of Sungrow's 1-Phase Hybrid Inverters. It covers models SH3.0RS, SH3.6RS, SH4.0RS, SH5.0RS, and SH6.0RS. The document outlines critical safety precautions, installation procedures, and important notices to ensure correct and safe operation.
For comprehensive details, users should refer to the full user manual available on the Sungrow support website: support.sungrowpower.com.
Important Safety Precautions
- Electrical Hazards: Inverters handle high voltages. All electrical work must be performed by qualified personnel in compliance with local and national standards. Disconnect all power sources before maintenance and wait for components to discharge.
- Thermal Hazards: Surfaces may become hot (exceeding 60°C) during operation. Avoid touching hot components.
- Qualified Personnel: Installation, maintenance, and country setting must be performed by trained and qualified personnel who understand the manual and relevant regulations.
- Component Handling: Avoid unnecessary touching of electronic components to prevent damage from electrostatic discharge (ESD).
Installation Requirements
Before installation, verify that all package contents are complete and intact. Ensure the cables used are intact and well-insulated. Operators must wear appropriate Personal Protective Equipment (PPE) at all times.
Any violation of safety instructions or improper operation can lead to severe injury, death, or device damage, and will void the warranty.
