download page - Anker US
Instruction Manual for ANKER models including: A9139, 51005003254, 521, 521 Power Strip Charging Station, Power Strip Charging Station, Strip Charging Station, Charging Station, Station
Anker 521 Power Strip Charging Station With 3 Outlets User Guide - Manuals Clip
File Info : application/pdf, 1 Pages, 56.64KB
DocumentDocumentAnker 521 Power Strip Overview CB D E AC Outlet Surge Protection Light Grounded Light USB-C Port E USB-A Port Using Your PowerStrip Safety Do not connect the power strip to an ungrounded outlet. Do not use with extension cords. Do not exceed electrical ratings. Use in dry locations and indoors only. Install the power strip away from heat-emitting appliances such as radiators. Keep children away from the power strip. If you want to clean the product, only use a dry cloth or brush. The product is not intended to be repaired by service personnel in case of failure or component defect (the product can be disposed of). Specifications AC Input AC Output Surge Energy USB-A Output USB-C Output Size 125V AC 60Hz 10A 125V AC 60Hz 10A 1250W (Total 1250W for socket-outlet 300J 5V 2.4A in total (2.4A Max Per Port) 5V 3A/9V 3A/15V 2A/20V 1.5A 116 x 50 x 32 mm Cable Length 5 ft Note: The USB Ports support an input voltage of 100-240V 50/60Hz. Tip: The surge protection feature can protect your computers, smartphones and other electronic equipment against voltage fluctuations, surges, and spikes. If the surge protection light is off, it indicates that surge protection is not functioning normally. For FAQs and more information, please visit: anker.com/support @anker_official @Anker Deutschland @AnkerOfficial @anker_jp @Anker Japan @Anker_JP @Anker Product Number: A9139 51005003254 V01 Descripción general Uso de la Power Strip CB D E Toma de CA Luz de protección contra sobretensiones Luz de protección de conexión a tierra Salida USB-C E Salida USB-A Consejo: Si la luz de protección contra sobretensiones está apagada, indica que no está funcionando con normalidad. Seguridad ° No conecte la Power Strip a una toma de corriente sin conexión a tierra. ° No la utilice con cables de extensión. ° No exceda las clasificaciones eléctricas. ° Úsela únicamente en lugares secos y en interiores. ° Instale la Power Strip lejos de aparatos que emitan calor, como radiadores. ° Mantenga a los niños alejados de la Power Strip. ° Si desea limpiar el producto, use solo un paño seco o un cepillo. ° El producto no está diseñado para que lo repare un técnico de servicio en caso de avería o algún desperfecto en sus componentes (el producto se puede desechar). Especificaciones Entrada CA 125V AC 60Hz 10A Salida CA 125V AC 60Hz 10A 1250W (Total 1250W for socket-outlet Energía de sobretensión 300J Salida USB-A Salida USB-C 5V 2.4A in total (2.4A Max Per Port) 5V 3A/9V 3A/15V 2A/20V 1.5A Tamaño 116 x 50 x 32 mm Longitud del cable 5 ft Nota: Los puertos USB admiten una tensión de entrada de 100-240 V 50/60 Hz. FCC Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: (1) Reorient or relocate the receiving antenna. (2) Increase the separation between the equipment and receiver. (3) Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. (4) Consult the dealer or an experienced radio / TV technician for help. The following importer is the responsible party. Company Name: Fantasia Trading LLC Address: 5350 Ontario Mills Pkwy, Suite 100, Ontario, CA 91764 Telephone: +1-800-988-7973 IC Statement This device complies with Industry Canada licenseICES-003. Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) This device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. Customer Service ES: Servicio de atención al cliente 18-Month Limited Warranty ES: Garantía limitada de 18 meses Lifetime Technical Support ES: Soporte técnico ilimitado support@anker.com +1 (800) 988 7973 Mon - Fri 9:00am - 5:00pm (PT)