Paxcess High Pressure Washer Quick Start Guide

Assembly and Operation

Follow these steps for quick setup:

1. Attach Handle: Secure the handle to the main body using two screws.
2. Attach Hose Reel Holders: Fasten the hose reel holders to the handle with four screws.
3. Attach Lance Holder: Mount the lance holder on the right side of the machine, ensuring the hose head emerges from the gap between the handle and main body.
4. Insert Lance: Push the lance firmly into the gun stock and twist to lock.
5. Connect Power Cable: Wind the power cable onto the power cable hook.
6. Connect Pressure Hose: Insert the pressure hose head into the water outlet and tighten.
7. Connect Water Inlet Hose: Attach the water inlet hose to the water inlet connector. Ensure the inlet pressure is not less than 3 bar.
8. Connect to Water Supply: Connect the other end of the water inlet hose to the water supply.
9. Connect Power: Plug the power cord into an outlet that matches the power specifications on the label.
10. Unlock Gun: Press the unlock button at the bottom of the gun stock.
11. Exhaust Air: Trigger the gun for a moment to release air. Water will flow after a few seconds.
12. Adjust Water Shape: Rotate the black top to regulate the water shape (direct stream spray or full fan spray) and water pressure.
13. Fill Detergent: Fill with suitable detergent for low-pressure cleaning (soap mode).
14. High Pressure Setting: Use the high-pressure setting for effective cleaning.

Accessory List:

• 1 Main body
• 2 Power cable hook
• 3 Cleaning pin
• 4 Water inlet connector
• 5 Lance holder
• 6 Lance
• 7 Gun handle
• 8 Hose reel
• 9 Hose reel holder
• 10 6*Screws
• 11 Hose reel handle

Customer Service:
Free Call: US(877) 756-8666
Mon-Fri: 9AM-5PM (PST)
Email: service@paxcess.com

Warm Tip: This quick start guide is not a substitute for the owner's manual. Users should read and understand the manual carefully before using the product.

Safety Tips

The pressure washer is a powerful cleaning tool. For safe operation, please adhere to the following precautions:

• Always wear safety goggles and closed-toe shoes to protect yourself from direct spray.
• Always find a flat, stable area to place the pressure washer before starting your project.
• It is advisable to test washing a small, hidden area first.
• Never point the gun at any person or pet.
• When cleaning wood surfaces, use the appropriate high-pressure nozzle to avoid damage.
• Always plug electric pressure washers into a properly grounded GFCI outlet.
• Hold the gun assembly firmly and engage the safety latches when not spraying to prevent accidental water release.
• After turning off the pressure washer, squeeze the trigger to release any residual pressure before disconnecting hoses and nozzles.
• The engine and motor can become hot during extended use; exercise caution when moving the washer.
• Never allow children to play around the pressure washer while it is in operation.
• Important: Do not operate the machine without water. If water flow stops during use, shut down the machine immediately (do not run without water for more than 1 minute) to prevent damage and ensure longevity.