SCHÜTTE WC Seat MDF with Soft-Close Mechanism - Installation Guide

Introduction

Welcome! You have purchased a high-quality and long-lasting product from SCHÜTTE. Please read these instructions carefully before assembly and observe the notes. Keep these instructions in a safe place and pass them on to any subsequent owners.

This product is available with installation instructions in multiple languages, including:

• German (DE)
• English (GB)
• French (FR)
• Italian (IT)
• Dutch (NL)
• Polish (PL)
• Romanian (RO)
• Russian (RU)
• Swedish (SE)
• Slovenian (SI)
• Slovak (SK)
• Turkish (TR)
• Czech (CZ)
• Danish (DK)
• Spanish (ES)
• Croatian (HR)
• Hungarian (HU)

Safety Notes

• [No standing/sitting on lid]
• [Warning symbol] Caution! Only close the toilet lid by pressing it lightly. Excessive pressure will damage the automatic lowering mechanism.
• We recommend checking the wing nuts regularly and tightening where necessary.

Instructions for Care

To prevent the surface from becoming scratched, only wipe with a little soapy water and a soft sponge, and dry with a soft cloth. [Water symbol]

ATTENTION! Do not use abrasive substances, caustic cleaning agents, disinfectants, or sprays with aggressive additives. Use chemical and cosmetic products carefully, as some may damage the surface of your toilet seat. [No aggressive cleaning agents]

Disposal

Your toilet seat is delivered in protective, recyclable packaging. Please dispose of the packaging in an environmentally suitable manner. [Recycling symbol]

At the end of its service life, do not throw the product into normal domestic waste. Consult your municipal administration for environmentally friendly disposal options.

For more information on recycling and disposal, visit quefairedemesdechets.fr.

Installation Guide

The following diagrams illustrate the assembly process. Please note that illustrations are figurative representations, and deviations from the actual product are possible. Technical modifications are reserved.

Parts Included

The package contains the following components:

• Mounting bolts (2x)
• Washers (2x)
• Nuts (2x)
• Mounting plates (2x)
• Cover caps for bolts (2x)
• Fixing bolts (2x)
• Wing nuts (2x)
• Cover caps for seat hinges (1x)

Approximate dimensions of the WC seat: Length approx. 43.5 cm, Width approx. 37.5 cm.

Assembly Steps

Diagram A: Mounting Mechanism Assembly

1. [Step 1] Insert the fixing bolt (part 1) into the mounting plate (part 2).
2. [Step 2] Attach the mounting plate assembly to the underside of the WC seat.
3. [Step 3] Tighten the fixing bolt securely.

Diagram B: Attaching Seat to Toilet Bowl

This diagram shows the general placement of the seat onto the toilet bowl, aligning the mounting plates with the bolt holes on the toilet. The mounting plates can be rotated if required for optimal alignment. (See Diagram C).

Diagram C: Adjusting Mounting Plates

If necessary, the mounting plates can be adjusted for better fit:

1. [Step 1] Loosen the screw holding the mounting plate.
2. [Step 2] Rotate the mounting plate to the desired position.
3. [Step 3] Tighten the screw to secure the plate.

Diagram D: Final Installation

This diagram shows the complete installation process:

1. [Step 1] Place the assembled seat onto the toilet bowl, aligning the mounting plates with the holes.
2. [Step 2] Insert the bolts through the mounting plates and toilet bowl holes.
3. [Step 3] Secure the bolts using the nuts and wing nuts.
4. [Step 4] Attach the cover caps over the hinge mechanism.

Refer to the numbered parts in Diagram D for specific components: 1. Fixing bolt, 2. Mounting plate, 3. Nut, 4. WC seat, 5. Bolt, 6. Wing nut, 7. Cover cap, 8. Toilet bowl.