Portable Air Conditioner PAC006-12K Quick Start Guide
Preparing the Window Panel
This section provides guidance on preparing the window panel for both horizontal and vertical sliding windows. The adjustable window kit is suitable for windows ranging from 20.5" to 39.4".
Accessories
| PARTS | NAME | QUANTITY |
|---|---|---|
| Hose inlet | Exhaust hose | x1 |
| Window slider without hole (A) | Window slider with hole (B) | 1 set |
| Bolts: Metal locking screw | x2 | |
| Remote Control | x1 | |
| Drainage hose | x1 | |
| Foam seal A (adhesive type) size: 1000×40×4mm | Foam seal B (no adhesive type) size: 1000×40×20mm | x2 x1 |
Installing the Window Panel and Air Conditioner
- Connect the hose connector to one end of the exhaust hose. Extend the side of the hose as needed.
- Connect the window kit adapter to the other end of the exhaust hose.
- Extend the adjustable window kit to the length of your window. Connect the exhaust hose to the window kit.
- Close your window to secure the kit in place. Ensure the window kit is held firmly. Use duct tape if necessary to seal any gaps between the adapter and the window sides for maximum efficiency.
- Attach the hose connector to the exhaust air outlet of the unit.
- Close your window to secure the kit in place. Ensure the window kit is held firmly. Use duct tape if necessary to seal any gaps between the adapter and the window sides for maximum efficiency.
- Adjust the louver at the air outlet, and then switch on the unit.
Control Panel
- Power Button: Turns the unit on/off.
- Mode Button: Switches between Cool, Heat, Dry (dehumidify), and Fan only modes.
- Increase (+) and Decrease (-) Buttons: Select to increase or decrease temperature or timer settings.
- Timer Button: Select to set a timer (0-24h).
- Fan Speed Button: Adjusts airflow speed.
- Swing Louver Button: Sets the air discharge louvers to oscillate left and right.
- Sleep Function Button (Only available in Cool Mode): Turns the Sleep Function on/off.
Display
- 1. Timer button
- 2. Fan speed button
- 3. Decrease button
- 4. Display screen
- 5. Increase button
- 6. MODE button
- 7. ON/OFF button
- A. Mode symbol
- B. Fan speed symbol
- C. Sleep symbol
- D. Timer symbol
Cleaning and Maintenance
Manual drainage
When the machine stops after the water is full, please unplug the power plug.
- Place a water container below the side water outlet behind the unit.
- During drainage, the body can be tilted slightly backwards.
- Unplug the water plug; the water will automatically flow into the water container.
- When the water is fully discharged, place the water plug back into place.
Air filter cleaning
For better performance and less operational noise, clean the appliance filter at least once every two months.
- Remove both grills from the back of the unit.
- If there is stubborn dirt or dust, immerse in lukewarm water and rinse a couple of times.
- Let the filter dry before re-attaching to the main unit.
Continuous drainage
- Switch off the unit before operating.
- Remove the plug of the water outlet opening, and keep it in a safe place.
- Securely and properly connect the drain hose and make sure it is not kinked and clear of obstruction.
- Place the outlet of the hose over a drain or bucket and ensure that water could freely flow out of the unit.
- Do not submerge the end of the hose into water; otherwise, it can cause an "Air Lock" in the hose.
To avoid water spillage: As the negative pressure of the condensate drain pan is large, tilt the drain hose downward towards the floor. The degree of inclination should exceed 20 degrees. Straighten the hose to avoid a trap existing in the hose.
