Onn. Round Stereo Speaker with Bluetooth® Wireless Technology
Quick Start Guide
What's in the Box?
Check to make sure you have everything below.
- A. 1 Round Stereo Speaker
- B. 1 USB-C® Charging Cable
- C. 1 FM Antenna
- D. 1 Quick Start Guide
Buttons Overview
Back Ports
A. Memory card slot: Insert a memory card (sold separately) to play music files.
B. USB-C® charging port: Use the included USB-C® cable to charge the speaker.
C. AUX In / FM Antenna Jack: Connect external devices via AUX cable (sold separately) to stream music. Insert the included FM Antenna cable into the AUX In / FM antenna jack while in FM mode to improve the radio reception.
Indicator Lights
The Round Speaker has two light indicators, one on the left side and the other on the right.
Battery Light Indicator
- Steady - Charging
- Steady - Fully Charged
- Flashing - Low Battery
Mode Light Indicator
- Steady - TWS Mode
- Flashing - TWS Pairing
- Steady - AUX / Memory Card Mode / FM Radio Mode
- Steady - Bluetooth® Mode
- Flashing - Bluetooth® Pairing
Charging Your Device
Plug the included USB-C® end of the USB cable into the charging port, and connect the other end of the cable to a power adapter (sold separately). Allow approximately four hours to fully charge the battery.
Note: We recommend using a USB wall adapter with a 5V output.
Initial Setup
- Once your device is fully charged, press and hold the Power button until you hear a voice prompt indicating the device has entered Bluetooth® pairing mode.
- On your smartphone or tablet, search for the Bluetooth® device named "Onn rnd speaker" and tap to connect.
- A prompt will play once pairing is successful.
TWS Mode
This device features TWS (True Wireless Stereo) technology, which allows you to play music on two of these speakers simultaneously, creating a surround sound experience.
- Make sure both speakers are turned on.
- Press the Mode button on both speakers to enter Bluetooth® Pairing Mode.
- On your smartphone or tablet, search for the Bluetooth® device named "Onn rnd speaker" and tap to connect to one of the speakers.
- Press and hold the Bluetooth® button on the speaker that is connected to your smartphone or tablet. The status light will flash purple.
- You will hear a sound prompt while the speakers are pairing. The status light will turn purple on both speakers once connected.
Memory Card Mode
Insert a memory card (sold separately) into the memory card slot. The speaker will automatically detect memory card playback and will begin to play music files.
AUX Mode
Connect your external device to the AUX input at the back of the speaker via AUX cable (sold separately) to enter AUX mode and start streaming audio from your device.
Press the Mode button to exit AUX mode.
NOTE: An AUX cable must be connected to detect AUX mode.
FM Radio Mode
- Press the Mode button until you reach Radio mode. FM radio will begin playing automatically.
- Press and hold the Pause/Play button to auto-scan radio stations. The speaker will pause on stations with a clear signal, and the full scan will complete after a couple of minutes. Any stations with a clear signal will automatically save.
- Press the Previous button or + Next button to play the previous or next saved station.
- Press and hold the Volume Down button or + Volume Up button to adjust the volume.
Note: When in FM radio mode, insert one end of the external FM antenna into the FM antenna jack, straighten it, and adjust it to a position in which the audio is clear. Pointing the antenna towards a window usually provides optimal results.
Resetting Your Device
If your speaker is not operating properly, you may reset it. To do so, use a small object - such as a paper clip - to press the button inside the AUX In port. Press and hold the button for approximately 2 seconds until the speaker powers off, and then power it on again as usual.
The Specs
- Bluetooth® Wireless Technology
- TWS Sync Mode (pair 2 of these speakers together)
- IPX4 water-resistant, rainproof, and splashproof
- Built-in rechargeable battery
- FM Radio
- Up to 10 hours of playtime
- Range 33 ft (10m)
- Memory card slot
- AUX In
- Output Power 5W*2
- Frequency Response 140Hz-18KHz
FCC Warning
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Caution: Changes or modifications to this product not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
FCC ID: 2AVRV100092910
Need help?
We're here for you every day from 7 a.m. 9 p.m. CST.
Give us a call at 1-888-516-2630
