Gadnic Handheld Corded Vacuum Cleaner

General Safety Precautions

1. This appliance is not intended for use by persons (including children) with lack of experience and knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.
2. This appliance is intended for indoor and household use only; not for outdoor, commercial and industrial use.
3. Keep the appliance and its power cord out of reach of children. Children should be supervised to ensure that they do not play with the appliance.
4. Do not use or place the appliance on sink, on hot surface, near heat source, or near the edge of table or counter.
5. To protect against fire, electric shock and injury, do not immerse power cord, plug or appliance in water or other types of liquid.
6. Ensure the voltage indicated on the Rating Label corresponding to the local power supply.
7. Do not leave the appliance operating unattended for any extended period of time.
8. Always place the appliance on a flat, level and dry surface.
9. The appliance must be switched off and mains plug removed from wall socket each time after use, and before cleaning and maintenance.

Important Safety Instructions

When using an electrical appliance, basic precaution should always READ ALL INSTRUCTIONS BEFORE USING (THIS APPLIANCE)

1. The Vacuum Cleaner is an electric appliance. It must be used in accordance with the operating conditions of the instructions. This instructions should be kept properly for future reference.
2. Check and confirm that the vacuum cleaner voltage must be consistent with the supply voltage.
3. It is strictly forbidden to inhale the following objects, otherwise it may damage the vacuum cleaner or cause fire:
   • heating objects, such as carbon fire etc
   • large cuts of sharp fragments, such as glasses etc
   • harmful substances, water & liquids (solvents, corrosive, etc.)
   • flammable and explosive goods, such as gasoline, alcohol products
4. When cleaning, repairing or temporarily not use the vacuum cleaner, the power supply must be turn off. When the power supply is cut off, pull the power cord and pull the plug out by holding the plastic part of the plug by hand.
5. Remember do not immerse the main vacuum cleaner in water, avoid approaching to heating equipment or exposure to the sun to avoid fire.
6. Do not let children play with the vacuum cleaner to avoid accidents.
7. In the following cases, do not use vacuum cleaner:
   • Fall and obvious damage or abnormal movement.
   • Power line is damaged
   When these happen, do not turn on the machine and send it to the maintenance service department designated by our company in time.
8. Avoid running for a long time in the condition of the suction inlet is blocked, to avoid damage to the motor and heat generation of the vacuum cleaner.
9. If the soft wire of the power supply is damaged, in order to avoid a danger, it must be replaced by professional manufacturer, its maintenance department or similar department.

SAVE THESE INSTRUCTIONS

When using the appliance, do not cover cord with throw rugs, runners, or similar coverings. Do not route cord under furniture or appliances. Arrange cord away from traffic area and where it will not be tripped over. Always unplug when not in use, do not around cord.

Product Parts List

SAVE THESE INSTRUCTIONS

Do not cover the cord with carpets, runners or similar coverings during use. Do not route the cord under furniture or appliances. Place the cord away from traffic areas and where it cannot be tripped over. Always unplug the appliance when not in use.

Part name of operation instruction:

1. Handgrip
2. Power Cord Hook
3. Tube
4. Tube Button
5. ON/OFF Button
6. Main body
7. Filter sealing ring
8. EPA Filter
9. Filter
10. Dust cup
11. Floor brush
12. Brush clip
13. Accessory brush
14. Nozzle

How To Use

1. As an upright vacuum cleaner

1. Please ensure that there is a filter in the dust box, all parts are connected together, fasten, and the power switch is OFF before use this vacuum cleaner.
2. Install the handgrip: insert the handgrip into the main body. (refer to Fig.1) When you insert the handgrip, please make sure to put it in a correct side. It only needs a little force to turn left or right in order to lock the metal tube hole correctly. You can also pull out the handgrip to check the tube fix well or not when you insert the tube. (WARNING: To prevent the lock being damaged, it doesn't allow using very strong force to turn left or right while fixing well).
3. Insert the plug into the outlet.
4. Turn on the switch.
5. Move the floor nozzle up and down to clean the floor. Note: Don't press the floor nozzle on the floor tightly, and don't move it breadthwise unless the floor is damaged.
6. Please shut off the power resource and pull the plug out after use it.

2. As a compact vacuum cleaner

1. Please remove the handgrip and floor nozzle and use suction brush. (Refer to Fig.2) Ensure that there is a filter in the dust box and the power switch is "OFF" before using this vacuum cleaner.
2. Uninstall the handgrip: Press the tube button and pull the handgrip out. (Refer to Fig.3)
3. Insert the plug into the outlet.
4. Turn on the switch.
5. Move the suction brush along the surface need to be cleaned, such as table, wall corner or clothes.
6. Please cut off the power and pull the plug out after using the cleaner.

3. How to clean your vacuum cleaner

Clean your vacuum cleaner in time. Or the motor would be damaged and the suction power would be lower.

1. Hold the main frame with one hand, and turn the dust cup anticlockwisely to unlock the dust cup. (Refer to Fig.4)
2. Catch the filter and pull it out. (Refer to Fig 5)
3. Clean the filter with water. (Refer to Fig 6)
4. Empty the dust box.
5. Get rid of dust on the filter. (The filter is washed with water and then dried)

Maintenance

1. Main unit and handgrip can be washed by a soft cloth with water. Dust box and floor nozzle can be washed with water. Noted: Don't wash your cleaner with alcohol or gasoline.
2. Filter: don't wash the filter with wash-machine. If it is very dirty or suction power reduces, you must get rid of the dust on it. Wash it with water and dry it completely.
3. Note: After emptying the dust box, please remember to put the filter and cyclone separator back into the dust cup. (Refer to Fig 7)

Any other servicing should be performed by an authorized service representative.

Troubleshooting

Please check following before send your product to service center.

Specifications

Circuit Diagram

A diagram showing the circuit of the vacuum cleaner is provided, including components like SW, ACL, ACN, a capacitor (C1), and an AC motor (M), with voltage ratings.

Servicing of Double-Insulated Appliances

A double-insulated appliance is marked with one or more of the following: The words "DOUBLE INSULATION" or "DOUBLE INSULATED" or the double insulation symbol (a square within a square).

In a double-insulated appliance, two systems of insulation are provided instead of grounding. No grounding means is provided on a double-insulated appliance, nor should any means for grounding be added to the appliance. Servicing a double-insulated appliance requires extreme care and knowledge of the system, and should be done only by qualified service personnel. Replacement parts for a double-insulated appliance must be identical to the parts they replace.