Origin21 Patio Furniture

Warranty Information

This warranty is for the original purchaser and applies to defects in materials and workmanship of your patio furniture, provided your unit is maintained with care and used only for personal, residential purposes. Frames are warranted to be free from defects in material or workmanship for three (3) years. Fabric is covered for one (1) year against defects in material or workmanship.

Exclusions:

• Items used for commercial, contract or other non-residential purposes.
• Display models.
• Items purchased "as is."
• Items damaged due to acts of nature, vandalism, misuse or improper assembly.
• Discoloration or fading of the finish or fabrics as a result of exposure to the elements, chemicals or spills.
• Tabletop breakage, corrosion or rusting of hardware and damages to frames or welds caused by improper assembly, misuse or natural causes.

For warranty service, call the customer service department at 888-251-1026, 8 a.m. - 8 p.m., EST, Monday - Sunday. You can also contact them at asca@lowes.com.

Safety Information

Please read and understand this entire manual before attempting to assemble, operate or install the product.

• 220 lbs. weight capacity (per chair)

Caution

• Assemble on a soft, non-abrasive surface.

Preparation

Before beginning assembly, make sure all parts are present. Compare parts with the package contents list and hardware contents list. Do not attempt to assemble the product if any part is missing or damaged.

Estimated Assembly Time: 25 minutes

Tools Required: None

Care and Maintenance

• Immediately clean any spot or stain.
• To clean, wash with a mild soap, rinse with water and let air dry.
• Do not use strong solvents or bleach as they may damage the surface.
• Use an outdoor cover (sold separately) to extend the life of the product.

Parts List

The following parts are included in the package:

• A x 2 (Chair Frames)
• B x 2 (Swivel Bases)
• C x 2 (Seat Cushions)
• D x 2 (Back Cushions)
• E x 1 (Tabletop)
• F x 1 (Table Base)
• G x 4 (Table Legs)

Hardware Contents

The following hardware is included:

• AA x 20 (Bolts)
• BB x 20 (Washers)
• CC x 1 (Allen Wrench)

Installation Overview

Warning: Do not tighten bolts until the product is completely assembled.

1. Attach the swivel bases (B) to the chair frames (A) using bolts (AA) and washers (BB).
2. Attach the table legs (G) to the table base (F) using bolts (AA) and washers (BB).
3. Attach the tabletop (E) to the table base (F) using bolts (AA) and washers (BB).
4. Place the seat cushions (C) and back cushions (D) onto the assembled chairs.

Diagrams illustrating the assembly steps are provided in the original document.