AEROPEX User Guide

Product Overview

This guide provides information on setting up, using, and maintaining your AfterShokz Aeropex headphones.

Key Components:

• Multifunction Button (A): Controls playback, calls, and voice assistant.
• Power/Volume+ Button (B): Powers the device on/off and adjusts volume.
• Volume- Button (C): Adjusts volume.
• Magnetic Charging Port: For charging the headphones.
• LED Indicator: Shows charging status and pairing mode.
• Microphone 1 & 2: For calls and voice commands.
• Earplugs (D): Optional accessory for blocking ambient noise.

How to Set Up Aeropex

1. Charge: Connect the headphones using the included magnetic charging cable. The LED indicator will change from red to blue when charging is complete.
2. Pair: With headphones powered off, press and hold the volume+ button until the LED indicator flashes red and blue to enter pairing mode.
3. Connect: Open your device's Bluetooth settings and select "Aeropex by AfterShokz." The LED indicator will flash blue, and Audrey will announce "connected."

Button Functions

Multifunction Button (A)

Power/Volume+ (B); Volume- (C)

Specifications

LED Indicator

Multipoint Pairing

Multipoint Pairing allows Aeropex to connect to two devices simultaneously, enabling seamless transitions between them.

1. Start with your headphones powered off.
2. Press and hold volume+ until the LED indicator flashes red and blue.
3. Press and hold the Multifunction Button and Power/Volume+ Button for 3 seconds. Audrey will say "multipoint enabled."
4. Open your first device's Bluetooth® menu and select "Aeropex by AfterShokz." Audrey will say "connected."
5. Turn your headphones off.
6. Re-enter pairing mode by pressing and holding the Power/Volume+ Button until the LED indicator flashes red and blue.
7. Open your second device's Bluetooth® menu and select "Aeropex by AfterShokz." Audrey will say "connected."
8. Turn your headphones off.
9. Turn your headphones on. Your headphones are now connected to both devices.
10. To turn off the Multipoint Pairing function: Repeat Step 1 and 2. Then press and hold the Multifunction Button and Volume- Button for 3 seconds until you hear "multipoint disabled."

Moisture Detection Alarm

These headphones can detect liquid such as water, sweat, and rain. If the headphones are plugged into the charger while wet, the LED indicator will flash red and blue, and the headphones will vibrate and emit a beep. In this case, remove the charging cable, dry the headphones completely, and then proceed with charging.

How to Reset Your Headphones

1. Start with your headphones powered off.
2. Enter pairing mode by pressing and holding volume+ until the LED indicator flashes red and blue.
3. Press and hold the Multifunction Button, Power/Volume+ Button, and Volume- Button simultaneously for 3-5 seconds, until you hear two beeps or feel vibrations.
4. Turn your headphones off. Aeropex is now reset and can be re-paired to your device.

Optional Accessories

Earplugs (D)

Use earplugs in environments where it is safe to block out ambient noise, such as on a train or airplane.

1. Roll earplugs firmly between fingers and place in ears.
2. While music is playing, to adjust EQ settings to reduce or enhance bass while wearing earplugs, press and hold volume+ and volume- buttons simultaneously.
3. Switch EQ to the original setting when you take out the earplugs.

Manufacturer

AfterShokz LLC

3200 Gracie Kiltz Lane, Suite 400 Austin, TX 78758