AfterShokz Titanium AS600

Product Overview

The AfterShokz Titanium AS600 utilizes bone conduction technology to deliver sound without blocking your ears, allowing for situational awareness. This manual provides setup, operation, and specification details.

Specifications

Setting Up Your Titanium

1. Charge: Charge the headphones using the included micro-USB cable. The LED indicator turns blue when charging is complete.
2. Pair: Press and hold the power button for 5 seconds to enter pairing mode. The LED indicator will flash blue and red.
3. Connect: Enable Bluetooth® on your device and select “Titanium by AfterShokz”. The LED indicator will turn blue when connected.

Register your Titanium at http://bit.ly/RegisterMyTitanium for warranty service.

Controls and Functions

The headphones feature a Multifunction Button (A), Volume Up/Power Button (B), and Volume Down Button (C).

Button Functions:

• Play/Pause Music: Click Button A once. (Audrey Says™: One beep)
• Skip to Next Song: Double-click Button A while music is playing. (Audrey Says™: One beep)
• Answer/End Call: Click Button A once. (Audrey Says™: One beep)
• Reject Call: Press and hold Button A for 2 seconds. (Audrey Says™: Two beeps)
• Voice Dial: Press and hold Button A for 2 seconds. (Audrey Says™: “Voice dial”)
• Redial Last Number: Double-click Button A. (Audrey Says™: “Last number redial”)
• Power On/Off: Press and hold Button B for 2 seconds. (Audrey Says™: Four beeps and “Welcome to AfterShokz”)
• Mute: Press and hold both Button B and C for 2 seconds during a call. (Audrey Says™: “Mute on” or “Mute off”)
• Change EQ Setting: Press and hold both Button B and C for 2 seconds while music is playing. (Audrey Says™: “Equalization changed”)
• Adjust Volume: Click Button B or C. (Audrey Says™: One beep)
• Check Battery Status: Click Button B or C while music is paused. (Audrey Says™: “Battery high, medium, low (or) charge me”)

Multipoint Pairing

Connect to two devices simultaneously:

1. Enter pairing mode.
2. Press and hold the Multifunction Button (A) and Volume Up/Power Button (B) for 2 seconds. (Audrey Says™: “Multipoint enabled”)
3. Pair with the first device. (Audrey Says™: “Connected”)
4. Shut down the headphones.
5. Re-enter pairing mode.
6. Pair with the second device. (Audrey Says™: “Second device connected”)
7. Restart the headphones.

Resetting Your Headphones

To reset your headphones, enter pairing mode, then press and hold the Multifunction Button (A), Volume Up Button (B), and Volume Down Button (C) simultaneously for 3 seconds.

LED Indicator Guide

• Solid red: Charging
• Solid blue: Charging complete
• Flashes red and blue: Pairing mode
• Flashes blue: Incoming call
• Flashes red every 2 minutes: Low battery

Optional Accessories

Earplugs (D)

Use earplugs in environments where it is safe to block ambient noise, such as on an airplane or train.

1. Roll earplugs firmly between fingers and place in ears.
2. To adjust EQ settings for bass while wearing earplugs, press and hold Volume Up and Down buttons simultaneously.
3. Switch EQ to normal when earplugs are removed.

Manufacturer Information

AfterShokz LLC, 6057 Corporate Dr., East Syracuse, NY 13057.