Eurotech Luxury Shower Doors
Installation Instructions
TRADITIONAL KD60
Product Overview
This document provides installation instructions for the Eurotech Traditional KD60 shower door. The hardware is designed to fit openings up to 60 inches wide. The shower door is available in configurations for an "outside door left" or "outside door right" setup.
Visual representation shows two shower door units: one labeled 'outside door left' and the other 'outside door right'.
Tools Required
The following tools are recommended for installation:
- Silicone applicator
- Level
- Drill
- Masonry Bit (Ø 1/8")
- Phillips Screwdriver
- Mallet
- Pencil
- Tape Measurer
- Painters Tape
- Allen Wrench (included with hardware)
⚠️ Important: This product is heavy and may require two people to install safely.
Congratulations on your purchase of your Eurotech Shower door, making your shower dreams come to life.
Packing List and Assembly
The following parts are included in the package:
| PART # | DESCRIPTION | Q'TY | PART # | DESCRIPTION | Q'TY |
|---|---|---|---|---|---|
| 1 | Wall Jamb | 2pcs | 6 | Towel Bar | 2set |
| 2 | Glass Guides x 6 | 6sets | 7 | Door Panel | 2pcs |
| 3 | Bumper Blocks x 6 | 6pcs | 8 | Bottom Guide | 1pc |
| 4 | Washers | 1pc | 9 | Bottom Sill | 1pc |
| 5 | Track | 2pcs | 10 | Blind Fastener | 2pcs |
| Roller Bracket | 4sets | 11 | Metal Receiver Knob | 1pc |
An assembly drawing illustrates the placement of numbered parts: Wall Jambs (1), Glass Guides (2), Bumper Blocks (3), Washers (4), Track (5), Towel Bar (6), Door Panels (7), Bottom Guide (8), Bottom Sill (9), Blind Fasteners (10), and Metal Receiver Knobs (11). Some parts are marked as 'Optional Installation Part'.
Cutting and Measurement Guidelines
Ensure accurate measurements and cuts for proper installation:
- Header Cut Formula: overall width minus 1/16"
- Wall Jamb Cut Formula: unit height minus 1-7/16"
- Bottom Sill Cut Formula: overall width minus 1/8"
Diagrams show how to cut the header, wall jamb, and bottom sill. One diagram illustrates the bottom sill placement with the door panels and bottom guide, referencing the centerline of the curb.
Configurations
The shower door system supports different configurations:
Dual Towel Bar Configuration
This setup includes two towel bars, attached using components like Bumper Knobs and Blind Fasteners.
A close-up diagram shows the dual towel bar configuration, indicating the attachment points for Bumper Knobs and Blind Fasteners.
Bi-pass Option
This option utilizes Blind Fasteners for securing components, allowing for a bi-pass sliding mechanism.
A close-up diagram illustrates the bi-pass option, highlighting the use of Blind Fasteners.
Installation Notes
The "outside door left" and "outside door right" configurations refer to the orientation of the door panels when viewed from the outside of the shower enclosure.
