Purelux Remote Control Wiring Harness: Operation, Pairing, and Wiring Guide

Important Safety Information

Caution! Only operate under the specified voltages (DC 10-30V). Maximum power: 300 W.

Remote Control Functions

Buttons

• ON: Press once to cycle through operating modes:
  1. Both lights ON
  2. Light #1 ON
  3. Light #2 ON
  4. Both lights flash alternatively. The flash pattern can be changed by pressing the FLASH button.
  The last used mode is saved when turned off and resumed after turning on again.
• FLASH: Switch between 6 flash modes. This button can also be used to turn the power ON.
• OFF: Switch the power OFF.

Battery Replacement

Change the battery when the remote indicator light is dim. Battery type: CR2032.

Pairing Instructions

Pairing One Remote Controller

1. Switch the main power OFF and then ON again.
2. Press and hold the ON-switch within 5 seconds.
3. The connected light blinks twice to indicate a successful pairing.

A new pairing will replace any previous pairings. You can control two or more harnesses with one remote controller by pairing them individually according to the above guide.

Pairing Multiple Remote Controllers to One Harness

1. Switch the main power OFF and then ON again.
2. Press and hold the ON-switch within 5 seconds. When the connected light blinks once, stop pressing the ON-switch and move to step three.
3. Repeat step two for each subsequent remote controller.

Wiring Instructions

Before wiring, disconnect the connection from the power source to prevent short circuits.

• Connect the red and black output wires to the lamp. Use a plug if available.
• Insulate all exposed wires to prevent short circuits.
• Connect the red input wire (with fuse) to the positive terminal of the power source.
• Connect the black input wire to the negative (ground).

Wiring Diagram Description: The system includes an input connection for power, typically a red wire (with an integrated 25A fuse) for the positive terminal and a black wire for the negative (ground) terminal of the power source. It provides two outputs, each with two 6.3mm female connectors, for connecting to the lights.

Flash Patterns

The FLASH button cycles through the following 6 modes:

1. Single
2. Strobe
3. Combo 1
4. Combo 2
5. Combo 3
6. Single slow