GrandPatio Steel Textilene K.D. Swivel Bar Chair

Before Assembly

Please separate and identify all parts, making sure that you have all of the parts listed.

To avoid any scratches during assembly, please assemble on a soft mat or similar.

Please assemble step by step and follow the instructions.

Washers must be used.

While each screw and nut is properly fastened, do not over fasten it.

Do not completely fasten each screw and nut until all the screws are properly fixed.

Parts List

• Part 1: Seat Base x1
• Part 2: Left Armrest Frame x1
• Part 3: Right Armrest Frame x1
• Part 4: Swivel Mechanism x1
• Part 5: Front Leg Frame x1
• Part 6: Rear Leg Frame x1
• Part 7: Footrest Bar x1
• Part 8: Swivel Post x1

Hardware

• A: Screws (M6x12mm) x12
• B: Screws (M6x20mm) x6
• C: Screws (M8x25mm) x2
• D: Washers (M6) x22
• E: Washers (M8) x2
• F: Nuts (M6) x20
• G: Nuts (M8) x2
• H: Allen Wrench x1
• I: Wrench x1

Important Assembly Note: Install all the relevant screws, but do not tighten them completely at the very beginning. Tighten the screws fully one by one.

Important Assembly Note: Don't tighten up the screw before you start next mounting during the installation. [X]

Assembly Steps

Step 1

Attach the seat base (1) to the swivel mechanism (4) using screws (F) and washers (D). Ensure the orientation is correct as shown in the diagram.

Step 2

Connect the left armrest frame (2) and right armrest frame (3) to the seat base (1) using screws (B), washers (D), and nuts (F). Secure the swivel post (8) to the base using screws (A), washers (D), and nuts (F).

Step 3

Assemble the front leg frame (5) and rear leg frame (6).

Step 4

Attach the assembled leg frames (5 and 6) to the swivel mechanism (4) using screws (A), washers (D), and nuts (F).

Step 5

Attach the footrest bar (7) to the leg frames (5 and 6) using screws (B), washers (D), and nuts (F).

Step 6

Connect the assembled seat and leg structure to the swivel post (8) using screws (A), washers (D), and nuts (F).

Step 7

Ensure all screws are tightened securely. The chair can now swivel 360°.

Care and Cleaning

1. To clean, wipe with a damp cloth. Do not use bleach, acid solvents, or abrasive cleaners on frame parts.
2. During varying weather conditions and winter periods, it is strongly recommended that the chair be stored in a dry area. With a suitable cover before storage, please ensure it is clean and dry.
3. In the event of bare metal showing due to scratches, it is preferred to treat with a rust-repelling varnish or similar.
4. Periodically check and ensure that all the screws are completely tightened.
5. A matching furniture cover is strongly recommended to extend the usage life-span.