User Guide for onn models including: 12 Series, Glass Screen Protector, Glass Screen Built-in Microbial Protection
File Info : application/pdf, 1 Pages, 131.42KB
DocumentDocumentCleaning Remove the case from your device to avoid interference with application. Clean the Screen 01 Clean the device screen with the wet wipe. Application Tray Apply the Tray 04 Snap the orange application tray over the front of your device. Tip: Be sure the edge labeled "Top" is at the top of your device. Glass Screen Protector with Built-in Microbial Protection Quick Start Guide Dry the Screen Dry with the microfiber cloth. Ensure the screen is completely dry before proceeding. Remove Dust Use the dust removal sticker to remove any fine particles from the device screen. 02 Screen Protector Application Remove Safety Film 05 03 Using the tab labeled "1-Back", peel away to expose the adhesive, removing completely. Note: Do not touch adhesive on the glass. 1 BACK Place the Screen Protector 06 With the adhesive facing your device place the screen protector down into the tray. Align the top edge of the glass and allow the glass to position itself into the tray. Final Steps Remove the Tray Carefully remove the application tray. 08 continued on the back Attach the Screen Protector 07 Press firmly down along the center to adhere the screen protector. Remove Air Bubbles 09 If there are any air bubbles, remove them by starting from the center and pushing firmly outward toward the edges. Note: Small bubbles may dissipate over the next 48 hours.Adobe PDF library 15.00 Adobe Illustrator 25.2 (Macintosh)