Philips NeoPix Ultra One Home Projector Quick Start Guide

Getting Started: Basic Setup

Follow these steps to set up your projector:

1. Connect Cables: Ensure all necessary cables (AV, Micro SD, HDMI 1, HDMI 2, USB, DC power) are connected to the corresponding ports on the projector.
2. Remove Lens Cover: Take off the protective cover from the projector lens.
3. Connect Power: Plug the DC power adapter into the projector's DC port and connect it to a power outlet.
4. Power On: Press the power button to turn on the projector. An indicator light will show it is active.
5. Adjust Focus: Use the adjustment knob on the projector to achieve a sharp image.
6. Adjust Keystone: Correct image distortion by adjusting the keystone setting, typically via a dial or button.

Safety Information

Please observe the following safety precautions:

• [caution: laser radiation]
• [hot surface warning]
• [wear eye protection]
• [electrical hazard]
• [do not expose to water]
• Ensure operation within the specified temperature range.

Controls and Operation

Familiarize yourself with the projector's controls:

Adjustment Knob

The adjustment knob is used for fine-tuning the image focus.

Navigation Keys

Located on the projector, these include Source, Menu, Navigator (directional pad), Return, and Power buttons.

Remote Control

The remote control provides access to all functions, including:

• Standby On/Off
• Select Input Source
• Settings
• Home Menu
• Back/Exit
• Volume Up/Down
• OK (Enter/Confirm)
• Directional Keys (Up/Down, Left/Right)

Connecting Devices

Connect your smartphones or tablets to the projector via HDMI:

For Apple Devices (Lightning Port):

Use an "Apple Lightning to Digital AV Adapter" along with an HDMI cable.

For USB-C Devices:

You can use either a "USB-C to HDMI adapter" with an HDMI cable, or a direct "USB-C to HDMI cable". Note: Android devices must support USB-C video output technology for this connection to work.

Product Information

Manufacturer: Screeneo Innovation SA

Address: Route de Lully 5C, 1131 - Tolochenaz - Switzerland

Website: www.philips.com/welcome

Support Email: philips.projector.eu@screeneo.com

FCC ID: 2ASRT-NPX641

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used under license.

Download the full user manual at: www.philips.com/support