BILT HARD Semi Trash Pump User Manual
This manual provides essential information for the safe operation and maintenance of your BILT HARD Semi Trash Pump.
Product Overview
The BILT HARD Semi Trash Pump is a powerful and efficient water pump designed for various applications. It features a 2-inch inlet and outlet, a flow rate of 158 GPM, and is powered by a robust 6.5 HP, 196cc 4-cycle engine. This pump is EPA Certified for environmental compliance.
Included accessories typically consist of a 50 ft discharge hose, a 12 ft suction hose, and complete fittings for immediate use.
Safety Precautions
Always prioritize safety when operating this equipment. Read and understand all instructions before use.
- Operate the pump on a level surface.
- Ensure adequate ventilation when operating the engine.
- Keep children and pets away from the operating area.
- Wear appropriate personal protective equipment (PPE), including safety glasses and gloves.
- Do not operate the pump in enclosed spaces due to exhaust fumes.
- Disconnect the spark plug wire before performing any maintenance.
Operation Instructions
Follow these steps for proper pump operation:
- Priming the Pump: Ensure the pump is properly primed before starting. Remove the priming plug and fill the pump housing with water. Replace the priming plug securely.
- Connecting Hoses: Attach the suction and discharge hoses to the appropriate ports. Ensure all connections are tight to prevent leaks.
- Starting the Engine: Follow the engine manufacturer's instructions for starting. Typically, this involves setting the choke, turning the fuel valve on, and pulling the starter cord.
- Operation: Once the engine is running smoothly and the pump is primed, water will begin to flow. Monitor the pump's performance during operation.
- Stopping the Pump: To stop the pump, turn off the engine according to the manufacturer's instructions. Close the fuel valve.
Maintenance
Regular maintenance ensures the longevity and optimal performance of your pump.
- Engine Oil: Check and change the engine oil regularly as per the engine manufacturer's recommendations.
- Air Filter: Clean or replace the air filter as needed to ensure proper engine combustion.
- Impeller and Seal: Periodically inspect the impeller and seals for wear or damage. Replace if necessary.
- Hoses and Fittings: Check hoses and fittings for cracks or leaks and tighten as required.
- Storage: If storing the pump for an extended period, follow proper storage procedures, which may include draining fuel and oil, and protecting the pump from the elements.
Troubleshooting
Refer to the following common issues and solutions:
- Pump not priming: Ensure the pump is completely filled with water, all connections are airtight, and the impeller is not clogged.
- Low flow rate: Check for obstructions in the suction hose or impeller, ensure the pump is adequately primed, and verify the engine is running at the correct speed.
- Engine not starting: Check fuel level, spark plug condition, air filter, and ensure the engine is properly primed.
Specifications
| Feature | Specification |
|---|---|
| Pump Size | 2 inch |
| Flow Rate | 158 GPM |
| Engine Horsepower | 6.5 HP |
| Engine Type | 196cc 4-Cycle |
| Certification | EPA Certified |
