GARDENA HandyMower 22/18V P4A Operator's Manual

1. Safety

IMPORTANT! Read the operator's manual carefully before use and keep for future reference.

Symbols on the product:

• [Read operator's manual] ?
• Keep bystanders away. ?
• Beware of sharp blades. Blades continue to rotate after the motor is switched off. ⚠️
• Remove disabling device before maintenance. ⚙️
• Secure the working area before starting to work.
• Watch out for hidden cables. ⚡
• Switch off: Remove the Battery before cleaning or maintenance.
• For the charger: Remove plug from the mains immediately if the cable is damaged or cut.

General safety warnings

Electrical safety for the charger

DANGER! Electric shock! Risk of injury due to electric shock. The product must be supplied through a residual current device (RCD) having a rated residual operating current not exceeding 30 mA.

Training

• Read instructions carefully, be familiar with controls and correct use.
• Never allow children or unfamiliar people to use the machine.
• Never operate the machine with people, children, or pets nearby.
• Operator/user is responsible for accidents or hazards to others or their property.

Preparation

• Wear substantial footwear and long trousers. Avoid loose clothing.
• Thoroughly inspect the area and remove thrown objects.
• Visually inspect blade, bolt, and assembly for wear/damage. Replace if necessary.
• Check supply and extension cords for damage. Disconnect immediately if damaged.

Operation

• Operate only in daylight or good artificial light.
• Avoid operating in wet grass.
• Be sure of footing on slopes.
• Walk, never run.
• Mow across slopes, never up/down.
• Exercise extreme caution when changing direction on slopes.
• Do not mow excessively steep slopes.
• Use extreme caution when reversing or pulling the machine.
• Stop blades if tilting for transport over non-grass surfaces.
• Never operate with defective guards or safety devices.
• Switch on motor carefully with feet away from blades.
• Do not tilt machine unnecessarily when starting.
• Do not start in front of discharge opening.
• Keep hands/feet clear of rotating parts and discharge opening.
• Do not transport machine while power source is running.
• Stop machine, remove disabling device, ensure all moving parts have stopped before: leaving machine, clearing blockages, checking/cleaning, after striking an object.
• Inspect for damage and repair before restarting.
• If machine vibrates abnormally, check for damage, replace/repair parts, tighten loose parts.

Maintenance and storage

• Keep nuts, bolts, screws tight.
• Check grass collector for wear.
• Replace worn/damaged parts for safety.
• Be aware of rotating blades on multi-blade machines.
• Be careful during adjustment to prevent finger entrapment.
• Allow machine to cool before storing.
• Blades can still be moved even when power is off.
• Use only genuine replacement parts and accessories.

Additional safety warnings

Battery safety

• Read all safety and general instructions. Failure to observe may result in electric shock, fire, serious injury.
• Supervise children during use, cleaning, maintenance.
• Charge only POWER FOR ALL system type PBA 18V batteries (1.5 Ah or more). Battery voltage must match charger voltage. Do not charge non-rechargeable batteries.
• Do not expose charger to rain or wet conditions.
• Keep charger clean.
• Always check charger, cable, plug before use. Stop if damaged. Do not open charger; have repaired by qualified specialist.
• Do not operate charger on easily ignited surfaces or in flammable environments.
• If power cord needs replacement, it must be done by GARDENA or authorized service center.
• Do not operate product while charging.
• (GB specific) Plug information.
• Only use battery with POWER FOR ALL system products.
• Recharge only with specified charger.
• Battery is supplied partially charged; fully charge before first use.
• Keep battery packs out of reach of children.
• Do not open battery (risk of short-circuiting).
• Improper use/damage may emit vapors (fire/explosion risk). Ensure ventilation, seek medical attention if adverse effects occur.
• If battery is damaged, flammable liquid may be ejected (irritation/burns). Avoid contact, rinse with water, seek medical attention if in eyes.
• If battery is damaged, liquid can eject onto surfaces; check/clean/change affected parts.
• Do not short-circuit battery pack. Keep away from metal objects when not in use.
• Battery can be damaged by pointed objects or external force (internal short circuit, burn, smoke, explode, overheat).
• Never service damaged battery packs.
• Protect battery against heat (sunlight, fire, dirt, water, moisture) (explosion/short-circuit risk).
• Operate/store battery between -20°C and +50°C.
• Charge battery between 0°C and +45°C.

Electrical safety

DANGER! Cardiac arrest! Product makes an electromagnetic field. May interfere with medical implants. Consult physician and implant manufacturer before use.

• Only use battery product between 0°C and 40°C.
• Do not use under wet conditions.
• Protect battery contacts from moisture.

Personal safety

DANGER! Risk of suffocation! Small parts can be swallowed. Keep toddlers away during assembly.

• Do not disassemble product beyond delivery status.
• Use gloves, wear slip-resistant shoes, wear eye protection.
• Do not overload mower.
• Never operate when tired, ill, or under influence of alcohol, drugs, medicine.
• Danger of slipping: in wet grass, on steep slopes, during transport.
• Be careful going backwards.
• Do not let product become wet.

DANGER! Risk of explosion! Do not operate in explosive atmospheres (flammable liquids, gases, dust). Power tools create sparks.

2. Assembly

DANGER! Risk of injury! Cut injury when product starts accidentally. Remove battery, safety key, use gloves before assembly.

To assemble the tube [Fig. A1/A2]:

1. Slide tube 1 into tube holder 2. Starting lockout 7 must point forward from handle 5. Ensure tube is fully inserted and noses b are in openings b of tube holder 2.
2. Tighten clamping sleeve 3.

3. Operation

DANGER! Risk of injury! Cut injury when product starts accidentally. Wait for blade to stop, remove safety key, use gloves before adjusting or transporting.

To charge the battery [Fig. O1/O2/O3]:

CAUTION! Note mains voltage! Power source voltage must match charger rating plate.

Intelligent charging process detects battery condition and charges optimally. Battery is treated with care and remains fully charged when stored in charger.

1. Open cover 4.
2. Push locking button > and remove battery Y from battery holder C.
3. Connect battery charger X into a mains socket.
4. Slide battery charger X onto battery Y.

Battery charge indicator at charger flashes green when charging. Illuminates permanently green when fully charged (Charging time: see 7. TECHNICAL DATA).

Examine charge status regularly. Disconnect battery from charger when fully charged.

Meaning of the indication elements:

Indication on the charger [Fig. O3]:

• Flashing of battery charge indicator : Charging procedure is indicated. Charging is only possible within allowable temperature range.
• Continuous lighting of battery charge indicator : Battery is fully charged, or battery temperature is outside allowable range. When battery is not inserted, indicates mains plug is inserted and charger is ready.

Battery charge status indication N on the product [Fig. O4/O8]:

Displayed for 5 seconds after starting:

• 67-100% charged: , and illuminate green.
• 34-66% charged: and illuminate green.
• 11-33% charged: illuminates green.
• 0-10% charged: flashes green.

If LED flashes green, battery needs charging. If error LED is illuminated or flashing, see 6. TROUBLESHOOTING.

Work positions:

Product has a safety device to prevent accidental starting when not in working position.

• Working position (approx. 22°-70°) [Fig. O5]: Tube 1 must be in this position for mower to start. Mower stops automatically if tube is moved out of this position.
• Parking position N (approx. 70°-105°) [Fig. O5/O6]: Tube 1 fully up. Mower cannot be started.
• Transport position _ (approx. 0°-22°) [Fig. O5/O7]: Mower can be carried by tube 1 or handle 5. Mower cannot be started.

To adjust the cutting height [Fig. O8]:

Adjustable from 30-50 mm in 3 positions.

1. Push height adjustment q towards wheel and set to desired position.
2. Let height adjustment q engage.

To start the mower [Fig. O1/O9]:

DANGER! Risk of injury! If product does not stop when start lever is released. Do not bypass safety devices or switches.

• Open lid 4.
• Insert battery Y into battery holder C until it engages audibly.
• Insert safety key 6 into handle and turn to position .
• Push starting lockout 7 with one hand and pull start lever 8 with the other. Mower starts, battery status N displayed for 5 seconds.
• Release starting lockout 7.

To stop:

1. Release start lever 8. Mower stops.
2. Turn safety key 6 to position and remove it.

Tips to use the mower:

• Cut lawn regularly (weekly) for a well-maintained lawn and denser growth.
• For long cutting intervals, first cut in one direction with highest height, then crosswise with desired height.
• If possible, cut dry grass; damp grass leads to uneven cutting.

Cutting performance and battery charge:

Lawn area depends on moisture, grass density, cutting height. Avoid frequent on/off cycles to preserve battery life. Maximize performance by increasing cutting height and frequent mowing.

Mulching:

Specially shaped blade provides optimum cutting and mulching. Grass is cut into small particles, fertilizing the lawn. Best mulching at 1/3 grass height cut (e.g., 60mm to 40mm). Max area of 50 m² achievable under optimum conditions.

4. Maintenance

DANGER! Risk of injury! Cut injury when product starts accidentally. Wait for blade to stop, remove safety key, use gloves before maintenance.

To clean the mower:

DANGER! Risk of injury! Do not clean with water/water jet. Do not clean with chemicals (petrol, solvents).

• To clean the underside of the mower [Fig. M1]: Lay mower on its side. Clean underside and blade 9 with brush and scraper 0 (no sharp objects).
• To clean the overside of the mower: Clean with a damp cloth.

To clean the battery and the battery charger:

Ensure surfaces and contacts are clean and dry before connecting. Do not use running water.

• Battery charger: Clean contacts and plastic parts with a soft, dry cloth.
• Battery: Occasionally clean ventilation slots and terminals with a soft, clean, dry brush.

5. Storage

Product must be stored away from children.

1. Turn safety key to position and remove it.
2. Remove battery.
3. Charge battery.
4. Clean mower, battery, charger (see 4. MAINTENANCE).
5. For space-saving storage, suspend mower from tube using GARDENA Tool Holder Art. 3501/3503 (do not suspend from handle).
6. Store mower, battery, charger in a dry, enclosed, frost-free place.

Disposal:

(in accordance with RL2012/19/EC) Product must not be disposed of as normal household waste. Dispose according to local environmental regulations.

IMPORTANT! Dispose of product via your municipal recycling collection centre.

Disposal of the battery:

GARDENA battery contains lithium-ion cells. Do not dispose of with normal household waste.

IMPORTANT! Dispose of batteries via your municipal recycling collection centre.

1. Discharge lithium-ion cells completely (contact GARDENA Service).
2. Protect battery contacts against short circuits.
3. Dispose of cells properly.

6. Troubleshooting

DANGER! Risk of injury! Cut injury when product starts accidentally. Wait for blade to stop, remove safety key, use gloves before troubleshooting.

To replace the blade:

DANGER! Risk of injury! Cut injury when blade is damaged, bent, out of balance, or has chipped edges. Do not use mower if blade is damaged. Do not regrind blade.

GARDENA spare parts available from dealer or GARDENA Service. Use only original GARDENA blade: GARDENA Replacement blade Art. 4105.

Let blade be replaced by GARDENA Service or authorized specialist dealer.

NOTE: For other malfunctions, contact GARDENA service department. Repairs must only be done by GARDENA service departments or specialist dealers approved by GARDENA.

7. Technical Data

Measuring process complying with: ¹⁾ EN 60335-2-77 ²⁾ RL 2000/14/EC

NOTE: The stated vibration emission value has been measured according to a standardised test procedure and can be used for comparison of one electric power tool with another. It can also be used for preliminary evaluation of exposure. The vibration emission value can vary during actual use of the electric power tool.

8. Accessories

• GARDENA Replacement Blade: As replacement for blunt blade. Art. 4105
• GARDENA Tool Holder: Tool holder for space-saving mower storage. Art. 3501 / 3503
• GARDENA System Battery PBA 18V/36 P4A, PBA 18V/45 P4A, PBA 18V/72 P4A: Battery for additional duration or for replacement. Art. 14902, Art. 14903, Art. 14905
• GARDENA Battery Charger AL 1810 CV P4A, GARDENA Battery Quick Charger AL 1830 CV P4A: Charger for fast charging the POWER FOR ALL System Batteries PBA 18V..W... Art. 14900-28 (UK), Art. 14900-52 (AU/NZ), Art. 14901-28 (UK), Art. 14901-52 (AU/NZ)

9. Service / Warranty

Service:

Please contact the address on the back page.

Warranty statement:

In the event of a warranty claim, no charge is levied for services provided. GARDENA Manufacturing GmbH grants a warranty for all original GARDENA new products for two years from the date of original purchase from the retailer, provided the devices have been for private use only. This warranty does not apply to second-hand products. It includes all significant defects proven to be material or manufacturing faults. Warranty is fulfilled by supplying a functional replacement product or repairing the faulty product free of charge; GARDENA reserves the right to choose between these options. Service is subject to the following provisions:

• Product used for its intended purpose as per operating instructions.
• Neither purchaser nor third party has attempted to open or repair the product.
• Only Original GARDENA replacement parts and wear parts have been used.
• Presentation of the receipt.

Normal wear and tear of parts (blades, blade fixing parts, turbines, light bulbs, V-belts/toothed belts, impellers, air filters, spark plugs), visual changes, wear parts, and consumables are excluded from the warranty.

This manufacturer's warranty is limited to replacement and repair. It does not constitute an entitlement to lodge other claims (e.g., for damages). This warranty does not affect statutory and contractual warranty claims against the dealer/retailer.

The manufacturer's warranty is governed by the law of the Federal Republic of Germany.

For warranty claims, return the faulty product with a copy of the receipt and a description of the fault, postage paid, to the service address.

Consumables:

The blade and the wheels are consumables and are not included in the warranty.

Contact Information

For general inquiries and service, please contact GARDENA Manufacturing GmbH, Central Service, Hans-Lorenser-Straße 40, D-89079 Ulm, Germany. Phone: (+49) 731 490-123, Email: service@gardena.com, Website: http://www.gardena.com.

Contact details for other countries are available in the original manual.