TW Steel VK63 Chronograph Watch

About TW Steel

TW Steel is a watch brand that harmoniously combines design and innovation. 'The Watch in Steel' leads the oversized market with style and quality guaranteed. TW Steel values the most important relationship of all – the one with the consumer. To express this, this document provides all the information needed to enjoy your TW Steel watch to the fullest.

Maintenance

TW Steel uses the best materials and carries out strict controls before the watch leaves the factory. The way in which you wear or treat your TW Steel will determine whether the appearance of the watch is maintained in the future, or whether it will deteriorate. To enjoy wearing your TW Steel as long as possible, here are some tips:

• If the watch comes into contact with hard or corrosive materials, this can cause damage, which, if it occurs regularly, will become clearly visible in the form of scratches.
• Your watch should be cleaned with a soft cotton cloth that is not impregnated with any cleaning material. Absolutely no cleaning materials should be used.
• It is advisable to regularly polish your watch with a soft cotton cloth.
• The watch is a precision mechanical instrument and should be treated as such. Adjusting the time or date, opening or closing the crown or crowncap, should not be done roughly, but carefully.

Display and Crown / Buttons

The watch features several components that are operated by the crown and buttons:

• Hour hand
• Minute hand
• Chronograph second hand
• Small second hand
• Chronograph minute hand (60 minute)
• 24 hour hand
• Button (A) (START / STOP)
• Button (B) (RESET)
• Crown at normal position
• Crown at first position (Date setting)
• Crown at second position (Time setting)

How to Reset (After Battery Change)

It is possible to reset the watch by the following two methods:

Method 1

1. Set the crown to the normal position.
2. Touch the AC terminal of the circuit block and the switch spring with conductive tweezers to reset the circuit.
3. The small second hand will move at two-second intervals for 10 seconds.

Method 2

1. Pull out the crown to the second click position.
2. Press button (B) for two seconds and release the button.
3. Push the crown back into the normal position.
4. The small second hand will move at two-second intervals for 10 seconds.

Note: If the crown is operated within these 10 seconds, the two-second interval movement will not activate. It is not necessary to set the chronograph hands after the battery is exchanged. If the chronograph hands' positions are incorrect, follow the procedure below to reset all chronograph hands to the "0" position.

[Button A (START)] → [Button A (STOP)] → [Button B (RESET)]

How to Set the Time

1. Pull out the crown to the second click position.
2. Turn the crown to set the hour and minute hands. (Check that AM / PM is set correctly.)
3. Push the crown back into the normal position.

Note: If the crown is pulled to the second position while the chronograph is started, the chronograph hands will continue to move. This is not a malfunction.

How to Set the Date

1. Pull out the crown to the first click position.
2. Turn the crown clockwise for date setting.
3. Push the crown back into the normal position.

Caution: Do not set the date between 9:00 P.M. and 3:00 A.M., as this may cause a malfunction.

How to Use the Chronograph

Press the buttons in the following order: [A] → [A] → [B]

1. Press button (A) to start the chronograph. The chronograph second hand will start moving.
2. Press button (A) again to stop the chronograph. The chronograph hands stop to indicate the elapsed time.
3. Press button (B) to reset the chronograph. All the chronograph hands will be reset to "0" position.

Details:

• The chronograph can measure up to 60 minutes.
• The chronograph stops after a measurement for 60 minutes.
• During chronograph operation, button (B) (reset) can be pushed without issue.