La Plus Belle Assembly & Installation Instructions
The drawing shown may not exactly match the product enclosed. However, the installation instructions do apply to this product.
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.
ASSEMBLING THE FIXTURE (Fig.1)
- Shut off the power at the circuit breaker box. Remove old fixture and all hardware from Junction Box. Carefully unpack your new fixture and lay out all the parts on a clear area. Take care not to lose any small parts necessary for installation.
- Fix mounting plate D on junction box with Box Screw. The side of the mounting plate marked "GND” must face out. The junction box is not included.
- Fix the top plate (B) on the mounting plate (D), and lock it securely with the Install the cap.
- Follow wiring instructions carefully. (see fig.2)
- Attach the light frame (E) to the suction top plate and tighten (F) with the mounting Screw.
- Install the light bulbs (not included) in accordance with the fixture's specifications. NOTE: DO NOT EXCEED THE MAXIMUN WATTAGE RATING!
Diagram Description (Fig.1):
A diagram illustrating the assembly of the fixture. Key components labeled include: Supply Ground Wire, Mounting Plate (D), Supply Wire, Junction Box (not included), Box Screw, Fixture Wire, Fixture Frame (E), Mounting Screw (F), and bulbs (not included). The diagram shows how the mounting plate attaches to the junction box and how the fixture frame is secured.
CONNECTING THE WIRES (Fig.2)
- Connect the electrical wires as follows. Connect the Black wire from the fixture to the black house (hot) Wire. Connect the white wire from the fixture to the white (neutral) house wire. Make sure all wire nuts are secured. You may wrap the connections with electrical tape. If your outlet box has a ground wires (green or bare copper) connect fixture's ground wire to it. Otherwise attach the bare copper fixture wire to the green ground screw on the mounting plate.
- Tuck the wire connections neatly into the wall junction box.
Your installation is now complete. Return power to the junction box and test the fixture.
Page 1 of 2
Wiring Diagram Description (Fig.2):
This section shows three possible wiring configurations. It illustrates the connection between FIXTURE WIRES and HOUSE WIRES. The configurations shown are:
- Fixture Wires: Black or Smooth; House Wires: Black (Hot)
- Fixture Wires: White or Ribbed; House Wires: White (Neutral)
- Fixture Wires: Bare Copper (Ground); House Wires: Green or Bare Copper (Ground)
