TFA Dostmann 60.3546.02 Radio-Controlled Wall Clock
Thank you for choosing this instrument from TFA.
Before you use this product:
- Please read the instruction manual carefully.
- The operating instructions are enclosed with the device or can be downloaded at www.tfa-dostmann.de/en/service/downloads/instruction-manuals
- This product should only be used as described within these instructions.
- Following and respecting the instructions in your manual will prevent damage to your instrument and loss of your statutory rights arising from defects due to incorrect use.
- Please take particular note of the safety advice!
- Please keep this instruction manual safe for future reference.
1. For Your Safety
- Unauthorized repairs, alterations or changes to the product are prohibited.
- Caution! Risk of injury: Keep this device and the battery out of reach of children. Small parts can be swallowed by children (under three years old). Batteries contain harmful acids and may be hazardous if swallowed. If a battery is swallowed, this can lead to serious internal burns and death within two hours. If you suspect a battery could have been swallowed or otherwise caught in the body, seek medical help immediately. Batteries must not be thrown into a fire, short-circuited, taken apart or recharged. Risk of explosion! Low batteries should be changed as soon as possible to prevent damage caused by leaking. Make sure the polarities are correct. Remove the battery if you do not use the device for a long period of time. Avoid contact with skin, eyes and mucous membranes when handling leaking batteries. In case of contact, immediately rinse the affected areas with water and consult a doctor.
- Important information on product safety! Do not expose the device to extreme temperatures, vibrations or shocks. Clean the device with a soft damp cloth. Do not use solvents or scouring agents. The device is only suitable for indoor use. Protect it from moisture!
4. Components
- A 1: Wall mounting hole
- A 2: M.SET button
- A 3: RESET button
- A 4: REC button
- A 5: Battery compartment
5. Getting Started
- Insert a new battery AA 1.5 V with the correct polarity (+/-).
- The device is ready for use.
5.1 Radio-controlled time reception
- The clock hands now travel to 12 o'clock automatically and the radio-controlled clock tries to receive the radio signal for 3 - 12 minutes. When the time code has been received after a few minutes, the clock hands automatically adjust to the current time.
- DCF radio reception takes place automatically 8 times a day.
- You can also activate the DCF reception manually. Press and hold the REC button for three seconds. The clock hands will then move to 12 o'clock and the clock tries to receive the radio signal again.
- If the clock cannot detect the DCF-signal (e.g. due to interference, transmitting distance, etc.), the time can be set manually.
5.2 Manual time setting
- Press and hold the M.SET button for three seconds.
- Press and hold the M.SET button until the desired time is indicated.
- Press the M.SET button briefly. The clock hands move forward minute by minute.
- Wait 8 seconds, the unit will save the setting automatically.
- The manually set time is overwritten once the DCF time signal is successfully received.
5.3 Note on radio-controlled time
- The time is transmitted from an atomic clock near Frankfurt am Main by a DCF-77 (77.5 kHz) frequency signal with a range of about 1,500 km. Your radio-controlled clock receives the signal, converts it and always shows the exact time. The adjustment of Daylight-Saving Time and Standard Time is also automatic.
- Avoid being close to possible sources of interference that may affect radio reception. It is recommended to keep a distance of at least 2 metres to possibly interfering sources (TV, computer, microwave, wireless phones, baby monitors) and large metal objects (e.g. refrigerator). Within solid walls, especially ones with metal parts, the transmission range can be reduced considerably. In extreme cases, please place the unit close to a window to improve reception.
- During night-time, the atmospheric interference is usually less severe. A single daily reception is adequate to keep the accuracy deviation under 1 second.
6. Mounting the Clock
- Securely attach the device with a solid nail or a screw and dowel at the respective location using the wall mounting hole. Before the final installation, make sure that the reception of the DCF time signal is possible.
7. Troubleshooting
Problem | Solution |
---|---|
Clock hands do not move | Ensure that the battery polarity is correct ➜ Change the battery |
No DCF reception | Press and hold the REC button for three seconds and activate the reception manually ➜ Wait for an attempt reception during the night ➜ Choose another place for your device ➜ Set the clock manually ➜ Check if there is any source of interference ➜ Restart the device according to the manual |
Incorrect indication | Press the RESET button using a pin ➜ Change the battery |
If your device fails to work despite these measures, contact the retailer where you purchased the product.
8. Waste Disposal
- This product and its packaging have been manufactured using high-grade materials and components which can be recycled and reused. This reduces waste and protects the environment. Dispose of the packaging in an environmentally friendly manner using the collection systems that have been set up.
- Disposal of the electrical device: Remove non-permanently installed batteries and rechargeable batteries from the device and dispose of them separately. This product is labelled in accordance with the EU Waste Electrical and Electronic Equipment Directive (WEEE). Please do not dispose of this product in ordinary household waste. As a consumer, you are required to take end-of-life devices to a designated collection point for the disposal of electrical and electronic equipment, in order to ensure environmentally-compatible disposal. Observe the current regulations in place!
- Disposal of the batteries: Never dispose of empty batteries and rechargeable batteries with ordinary household waste. They contain pollutants which, if improperly disposed of, can harm the environment and human health. As a consumer, you are required by law to take them to your retail store or to an appropriate collection site depending on national or local regulations in order to protect the environment. The symbols for the contained heavy metals are: Cd=cadmium, Hg=mercury, Pb=lead.
9. Specifications
- Power consumption: Battery 1 x AA 1.5 V (not included). We recommend Alkaline batteries!
- Housing dimension: Ø 250 x 40 mm
- Weight: 379 g (device only)
No part of this manual may be reproduced without written consent of TFA Dostmann. The technical data are correct at the time of going to print and may change without prior notice. The latest technical data and information about this product can be found in our homepage by simply entering the product number in the search box.
EU Declaration of Conformity
Hereby, TFA Dostmann declares that the radio equipment type 60.3546 is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: www.tfa-dostmann.de/service/downloads/ce
Contact:
www.tfa-dostmann.de
E-Mail: info@tfa-dostmann.de
TFA Dostmann GmbH & Co.KG, Zum Ottersberg 12, 97877 Wertheim, Germany