Danfoss React™ M30 x 1.5 Thermostatic Sensor Installation Guide
Product: Danfoss React™ M30 x 1.5 thermostatic sensors series
Model: Danfoss React™ M30 x 1.5 / 015G3038
Manufacturer: Danfoss A/S
Installation
Installation | Montage | Installation | Instalación
Diagram 1: Shows the Danfoss React™ thermostatic sensor being attached to a radiator valve body. The sensor has an M30 x 1.5 thread.
Diagram 2: Shows the sensor being screwed onto the valve body. A detail view highlights the connection mechanism, with the number '5' indicated.
Diagram 3: Shows the sensor fully attached and locked onto the valve body. A torque wrench indicates '15Nm', and a dial marked '32' is visible on the sensor.
- Attach the thermostatic sensor to the radiator valve body.
- Secure the sensor onto the valve body.
- Tighten to 15Nm.
BIV Installation
BIV Installation | Montage | Installation | Instalación
This section details the installation process for BIV (Built-in Valve) configurations, which follows similar steps to the general installation.
- Attach the thermostatic sensor to the BIV valve body.
- Secure the sensor onto the BIV valve body.
- Tighten to 15Nm.
Temperature Limitation (MAXIMUM)
Temperature Limitation | Temperaturbegrenzung | Limite de température | Limitación de temperatura (MAXIMUM)
Series of diagrams illustrating how to set the maximum temperature limit. The thermostatic sensor dial, marked with numbers 1 through 5 and MIN/MAX, is adjusted. An example shows setting the maximum limit to '4'. Arrows indicate the direction of rotation for adjustment.
- Set the desired maximum temperature limit by adjusting the sensor dial.
- For example, set the dial to '4' to limit the maximum temperature.
- This setting restricts the upper range of temperature control.
Temperature Limitation (MINIMUM)
Temperature Limitation | Temperaturbegrenzung | Limite de température | Limitación de temperatura (MINIMUM)
Series of diagrams illustrating how to set the minimum temperature limit. The thermostatic sensor dial is adjusted. An example shows setting the minimum limit to '2'. Arrows indicate the direction of rotation for adjustment.
- Set the desired minimum temperature limit by adjusting the sensor dial.
- For example, set the dial to '2' to limit the minimum temperature.
- This setting restricts the lower range of temperature control.
Shut Off
Shut off | Abschließen | Couper | Cerrar
Diagrams show the process of detaching the Danfoss React™ thermostatic sensor from the radiator valve body. The second and third images illustrate the release mechanism and removal.
- Prepare to detach the sensor from the valve body.
- Release the sensor from the valve body using the designated mechanism.
- Remove the sensor.
Theft Protection & Blind Mark
Theft protection | Diebstahlschutz | Protection contre le vol | Protección contra robo
Diagrams show the sensor being attached for theft protection. The code number 013G5287 is provided.
Blind mark | Blinde markierung | Marque aveugle | Marca ciega
A 'Blind mark' section highlights setting '3' on the sensor dial, indicating a specific configuration or security feature.
Theft protection is applied during installation.
The blind mark indicates a specific setting, such as '3', on the sensor dial.
