Fisher-Price HTX00 Panda Guitar Toy

Product Overview

This is the Fisher-Price HTX00 Panda Guitar toy, designed to entertain and educate children through music, shapes, counting, and colors.

The toy features interactive buttons that introduce shapes and counting. A toggle allows for whammy bar sound effects. The spinning element plays fun phrases, music, and songs that teach shapes, counting, and colors.

Model Number: HTX00

Battery Information and Power

This toy requires three (3) AA (LR6) batteries, which are included for demonstration purposes. For longer play, alkaline batteries are recommended.

Battery Safety Information

To avoid battery leakage and potential damage:

• Do not mix old and new batteries or batteries of different types (alkaline, carbon-zinc, rechargeable).
• Insert batteries as indicated inside the battery compartment, observing the correct polarity (+ and -).
• Remove batteries during long periods of non-use. Always remove exhausted batteries and dispose of them safely. Do not dispose of the product or batteries in fire, as they may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the product before charging.
• If removable, rechargeable batteries are used, they should only be charged under adult supervision.

Battery Replacement Instructions

A Phillips screwdriver (not included) is required for battery replacement. Only adults should replace batteries.

1. Loosen the screw on the battery compartment door and remove the door.
2. Remove the exhausted batteries and dispose of them properly.
3. Insert three new AA (LR6) alkaline batteries, ensuring correct polarity.
4. Replace the battery compartment door and tighten the screw.
5. Slide the power-volume switch to the desired setting: ? ON with low volume, ?? ON with high volume, or ⚪ OFF.

When sounds or lights become faint or stop, it is time for an adult to change the batteries.

If the toy begins to operate erratically, reset the electronics by sliding the power-volume switch OFF and then back ON again.

Cleaning Instructions

To clean, wipe all parts of the toy with a damp cloth. Do not immerse the toy in water.

Environmental Protection

Do not dispose of this product or batteries with household waste. The ♻️ symbol indicates that this product should not be treated as household waste. Check your local authority for recycling advice and facilities.

Link Squad™ System Synchronization

Learning is better when they're together! The Link Squad™ toys are designed to interact with each other.

Note: Toys are sold separately and subject to availability.

How to Sync Your Link Squad™ Toys:

1. Turn power OFF on each toy.
2. Turn power ON.
3. Watch and listen as Link Squad™ toys respond to each other in fun ways during play.

Troubleshooting Sync Issues: If one Link Squad™ toy doesn't seem to be interacting with others, turn all of them OFF and then back ON again.

Language Compatibility: Link Squad™ toys are available in different languages. They only sync with other Link Squad™ toys of the same language.

Compatibility Note: Link Squad™ toys will not interact with Linkimals™ toys. To ensure intended interaction, toys must belong to the same product line.

Compliance and Contact Information

This product complies with relevant regulations. For detailed information, please refer to the original documentation.

Contact Information:

• United States: Fisher-Price, Inc., 636 Girard Avenue, East Aurora, NY 14052. Consumer Services: 1-800-432-5437.
• Canada: Mattel Canada Inc., 6155 Freemont Blvd., Mississauga, Ontario L5R 3W2. Consumer Services/Service à la clientèle: 1-800-432-5437. www.service.mattel.com.
• Great Britain: Mattel U.K. Limited, The Porter Building, 1 Brunel Way, Slough SL1 1FQ, UK. www.service.mattel.com/uk.
• Netherlands: Mattel Europa B.V., Gondel 1, 1186 MJ Amstelveen, Nederland.
• Australia: Mattel Australia Pty. Ltd., 658 Church Street, Locked Bag #870, Richmond, Victoria 3121 Australia. Consumer Advisory Service 1300 135 312.
• New Zealand: 16-18 William Pickering Drive, Albany 1331, Auckland.
• South Africa: Mattel South Africa (PTY) LTD, Office 102 13, 30 Melrose Boulevard, Johannesburg 2196.

FCC Statement (United States Only)

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.

Note: Changes or modifications not expressly approved by the manufacturer responsible for compliance could void the user's authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Déclaration FCC (États-Unis Seulement)

Cet équipement a été testé et jugé conforme aux limites de classe B pour un appareil numérique en vertu de l'article 15 de la réglementation de la FCC. Ces limites ont été instaurées pour fournir une protection raisonnable contre toute interférence nuisible dans une installation résidentielle. Cet équipement génère, utilise et peut émettre de l'énergie radiofréquence. S'il n'est pas installé et utilisé conformément aux instructions, il peut provoquer des interférences sur les communications radio. Cependant, il n'est pas garanti que des interférences ne se produiront pas dans certaines installations. Si cet équipement cause des interférences à la réception radio ou télévisée (ce qui peut être vérifié en éteignant l'appareil puis en le remettant sous tension), l'utilisateur peut tenter de les résoudre en suivant une ou plusieurs des mesures ci-après :

• Réorienter ou déplacer l'antenne réceptrice.
• Augmenter l'espace entre l'appareil et le récepteur.
• Pour obtenir de l'aide, contacter le vendeur ou un technicien radio/télévision expérimenté.

Remarque : Tout changement ou modification de cet appareil n'ayant pas été expressément approuvé par les parties responsables de sa conformité peut entraîner l'annulation du droit d'exploitation de l'équipement par l'utilisateur.

Cet appareil est conforme à l'article 15 de la réglementation de la FCC. L'utilisation de ce dispositif est autorisée seulement aux deux conditions suivantes : (1) il ne doit pas produire de brouillage nuisible, et (2) il doit pouvoir tolérer tout brouillage radioélectrique reçu, même si ce brouillage est susceptible de compromettre son fonctionnement.

Canada Compliance: This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device.

Conformité Canada : L'émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d'Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) L'appareil ne doit pas produire de brouillage; (2) L'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.

©2023 Mattel. Printed in China. HTX00-0970-1103174846-DOM