iScooter F3 User Manual
IMPORTANT! Read carefully and keep for future reference.
Illustrations of product, accessories, and user interface in the user manual are for reference purposes only. Actual product and functions may vary due to product enhancements.
Package Contents
- Scooter
- Seat
- Spare Inner Tube
- Ignition Key
- Rear Basket & Mounting Hardware
- Wrench Kit
- User Manual & Safety Instructions
- Charger
Product Overview
The iScooter F3 features the following components:
- 1. Display & Button: Control panel for mode selection and information display.
- 2. Throttle: Controls acceleration.
- 3. Brake Lever: Controls braking.
- 4. Handlebar Height Adjustment Clamp: Allows adjustment of handlebar height.
- 5. Folding Latch & Lock Ring: Mechanism for folding the scooter.
- 6. Headlight: Front illumination.
- 7. Charging Port: Port for connecting the charger.
- 8. Ignition Keyhole: Slot for the ignition key.
- 9. Bell: Audible signaling device.
- 10. Seat: For rider comfort.
- 11. Rear Basket: For carrying items.
- 12. 2-in-1 Taillight & Brake Light: Rear illumination and brake light.
- 13. Seatpost Taillight Mount: Mounting point for the taillight.
- 14. Kickstand: Supports the scooter when parked.
Quick Setup / Installation
Step 1: Handlebar Assembly
Connect the T-handlebar to the handlepost, then lift the handlebar to the riding position. Ensure the clamp is securely fastened.
Step 2: Folding Latch Security
Close the folding latch securely, then rotate the lock ring to lock the folding latch in place. Pay attention to minimum insertion marks.
Step 3: Handlebar Height Adjustment
Adjust the handlebar to your desired height, then close the clamp securely.
Step 4: Seatpost Installation
Open the lever of the seatpost clamp, insert the seatpost into the seat tube, then close the lever securely. Pay attention to minimum insertion marks.
Step 5: Rear Taillight Installation (if applicable)
Disconnect the power cable of the pre-installed taillight. Remove the taillight's bolts, then the taillight. Attach the taillight to the back of the rear basket, then tighten its bolts.
Step 6: Rear Basket Installation
Attach the basket brackets to the rear basket, then tighten their bolts securely. Attach the rear basket to the scooter, tighten its bolts, then reconnect the power cable of the taillight.
WARNING: Ensure all clamps and latches are tightened firmly for riding safety.
Display and Operations
Display Information
- 1. Brake Applied: Indicates if the brake is engaged.
- 2. Real-time Speed: Displays current speed (km/h or mph).
- 3. VOL (Battery Voltage): Shows battery voltage.
- TRIP: Displays distance traveled on the current trip.
- ODO: Displays the total distance traveled.
- 4. Battery Level: Indicates remaining battery charge.
- 5. M Button: Used for mode selection and other functions.
- 6. Riding Mode: Displays the current riding mode (ECO, TOUR, SPORT).
Basic Operations
- Power ON: Insert and turn the ignition key clockwise to the first click.
- Power OFF: Turn the ignition key counterclockwise to the end.
- Headlight ON/OFF: After powering on, turn the ignition key clockwise to the second click to turn on the headlight and taillight. Turn off by reversing the action.
- Switch Riding Mode: Press the M button twice.
- Imperial/Metric System: Press the M button 3 times.
- VOL/TRIP/ODO Display: Hold the M button for 3 seconds.
Error Codes
If an error code appears on the display, contact iScooter support. The following codes may be displayed:
| Code | Meaning |
|---|---|
| E10 | Communication Fault |
| E14 | Throttle Fault |
| E15 | Brake Lever Fault |
| E16 | Motor Hall Sensor Fault |
| E50 | Over-Voltage |
About Charging
- The scooter is fully charged when the charger indicator changes from red to green.
- The scooter has charging protection and will automatically stop charging after a full charge. Overcharging is not recommended.
- Keep the charging port cover closed when not charging.
- The scooter cannot be turned on while charging.
Specifications
| Feature | Specification |
|---|---|
| Unfolded Size | 40.6 x 21.9 x 37.4 in (1030 x 555 x 950 mm) |
| Folded Size | 40.6 x 21.9 x 24 in (1030 x 555 x 610 mm) |
| Weight | 43 lbs (19.5 kg) |
| Battery Capacity | 48 V, 13 Ah |
| Motor Power | 1000 W |
| Wheel Diameter | 10 in. |
| Range | 34-37 miles (55-60 km) * |
| Max Load Capacity | 264 lbs (120 kg) * |
| Recommended Age | 14+ |
| Operating Temperature | 28.4°F-95°F (-2°C-35°C) |
| Charger Input | AC 100-240 V, 50/60 Hz |
| Charger Output | DC 54.6 V, 2 A |
| Charging Time | 6-7 h |
* Range and load capacity figures are approximate and may vary.
Important Information
Range Details
The specified range is measured under conditions of 100% battery, a load of 154 lbs (70 kg), and a speed of 9 mph (15 km/h). Actual range depends on factors like load, humidity, wind speed, and riding habits.
Load Capacity
The scooter is designed for a maximum load of 264 lbs (120 kg). For optimal riding experience, it is recommended to use up to 70% of the maximum load.
CE Warning
- This appliance is not intended for use by persons (including children) with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge, unless supervised.
- Children should be supervised to ensure they do not play with the appliance.
Disposal of Electrical and Electronic Equipment
The crossed-out garbage bin symbol indicates that this product must be disposed of separately from unsorted municipal waste. Do not dispose of in residual waste bins or yellow bins. If the product contains batteries not permanently installed, remove them before disposal and dispose of them separately.
Declaration of Conformity
For the full text of the EU Declaration of Conformity, visit: https://www.iscooterglobal.de/pages/konformitatserklarung
Customer Service & Manufacturer
Customer Service
Contact iScooter support for issues related to riding, maintenance, safety, or errors.
United States
- Website: www.iscooterglobal.com
- Email: support@iscooterglobal.com
- Phone: +1 888 4968123
Germany
- Website: www.iscooterglobal.de
- Email: support@iscooterglobal.de
- Phone: +49 800 0003728
France
- Website: www.ihoverboard.fr
- Email: support@ihoverboard.com
- Phone: +33 805980335
Manufacturer
Shenzhen Xincheng Times Technology Co., Ltd.
Address: 104-105, Block C, Donghai Wang Building, No.369 Bulong Road, Ma'antang Community, Bantian Street, Longgang District, Shenzhen
EU Representative
GAVIMOSA CONSULTORIA, SOCIEDAD LIMITADA
Address: CASTELLANA 9144, 28046 Madrid
Email: compliance.gavimosa@outlook.com
Contact: Jorge Willson
Phone: +49 800 036 6222
