Perel BG90014 Electronic Safe Box
User Manual
Introduction
To all residents of the European Union
Important environmental information about this product
This symbol ♻️ on the device or the package indicates that disposal of the device after its lifecycle could harm the environment. Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken to a specialized company for recycling. This device should be returned to your distributor or to a local recycling service. Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing Perel! Please read the manual thoroughly before bringing this device into service. If the device was damaged in transit, do not install or use it and contact your dealer.
Safety Instructions
Read and understand this manual and all safety signs before using this appliance.
? Indoor use only.
This device can be used by children aged from 8 years and above, and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning the use of the device in a safe way and understand the hazards involved. Children shall not play with the device. Cleaning and user maintenance shall not be made by children without supervision.
General Guidelines
Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.
All modifications of the device are forbidden for safety reasons. Damage caused by user modifications to the device is not covered by the warranty.
Only use the device for its intended purpose. Using the device in an unauthorised way will void the warranty.
Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the dealer will not accept responsibility for any ensuing defects or problems.
Nor Velleman nv nor its dealers can be held responsible for any damage (extraordinary, incidental or indirect) – of any nature (financial, physical...) arising from the possession, use or failure of this product.
Images are for illustrative purposes only ?
Keep this manual for future reference.
Overview
Refer to the illustrations on page 2 of this manual.
| 1 | battery compartment | 5 | emergency lock |
| 2 | bolts | 6 | master lock |
| 3 | storage hooks | 7 | control panel |
| 4 | reset button | 8 | confirming button |
Installing the Safe
To reduce the risk of theft, the safe can be secured to the floor, wall or in a cupboard. Use the predrilled holes at the bottom and/or back to define the position of the drill holes. Fix the safe using the supplied expansion bolts. Install the safe in a horizontal position.
Diagram Description: The safe can be secured to the floor, wall, or in a cupboard using pre-drilled holes. The diagrams show marking drill holes and fixing the safe with bolts.
Operation
6.1 First Use/Emergency Mode
❗ The override key will open the safe without need of a code. It is therefore important never to store the override key inside or near the safe. The override key is also the only key with which you can open the safe in case of a lost code or empty batteries.
- Insert the override key in the emergency lock and turn to the left.
- At the same time, turn the master lock to the right.
6.2 Installing the Batteries
- Open the battery compartment and install the batteries according to the indicated polarity. It is recommended to use alkaline batteries only.
- Close the battery compartment.
- Change the batteries as soon as the red low battery LED lights.
Removing the batteries will delete the code. Re-enter your personal code. Refer to Setting/Changing the Personal Code.
6.3 Setting/Changing the Personal Code
- With the door open, press the reset button.
- When the yellow LED burns, enter a personal code (3 to 8 digits) and press the confirming button (C, E). The two beeps mean that your code has been validated. Please re-enter your code and confirm if the yellow LED flashes and the safe beeps three times.
- Proceed with programming the manager code.
6.4 Setting/Changing the Master Code
- With the door open, press 0 (zero) twice and press the reset button.
- When the yellow LED burns, enter a master code (3 to 8 digits) and press the confirming button (C, E). The two beeps mean that your code has been validated. Please re-enter your code and confirm if the yellow LED flashes and the safe beeps three times.
6.5 Closing the Door
Close the door and turn the master lock to the left.
6.6 Opening the Door
- Enter your personal code and press the confirming button (C, E).
- As soon as the green LED burns, turn the master lock to the right and pull the door open. Please retry if the yellow LED flashes and the safe beeps three times.
Diagram Description: Shows the keypad and the rotation of the lock mechanism for opening the door.
6.7 Auto Lock
The safe will disable the keypad automatically for 20 seconds after three erroneous code entries.
After three more erroneous code entries, the keypad will be locked for 4 minutes and 30 seconds.
Disabling the alarm can only be done by opening the safe with the override key and removing the batteries.
Cleaning and Maintenance
Occasionally wipe with a damp cloth to keep it looking new. Do not use harsh chemicals, cleaning solvents or strong detergents.
Technical Specifications
| Outer dimensions | 17 x 23 x 17 cm |
| Inner dimensions | 16.8 x 22.8 x 12 cm |
| Steel thickness | |
| Body | 1 mm |
| Door | 2.5 mm |
| Weight | 2.3 kg |
| Power supply | 4x AA/LR6 1.5 V batteries (not incl.) |
| Capacity | 4.6 L |
Use this device with original accessories only. Velleman nv cannot be held responsible in the event of damage or injury resulting from (incorrect) use of this device. For more info concerning this product and the latest version of this manual, please visit our website www.velleman.eu. The information in this manual is subject to change without prior notice.
COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All worldwide rights reserved. No part of this manual may be copied, reproduced, translated or reduced to any electronic medium or otherwise without the prior written consent of the copyright holder.
