Jonsbo C6 Computer Case Installation Guide
Package Contents
| Image | Quantity | Used For |
|---|---|---|
| A | 17 | Screw - PSU, MB, HDD |
| B | 17 | Washer |
| C | 8 | Screw - SSD |
| D | 1 | HEX wrench socket |
| E | 1 | Standoff |
| F | 1 | Cable tie/Velcro |
| G | 5 | Cable tie |
| H | 8 | Fan Screw |
Connectors
USB 3.0: Standard USB 3.0 header connector for front panel USB ports.
HD AUDIO: High Definition Audio header for front panel audio jacks.
F PANEL: Front Panel header for power button, reset button, LEDs, and HDD activity.
Parts Diagram
- 1: Top Mesh Panel
- 2: Right Mesh Panel
- 3: Left Mesh Panel
- 4: Front Mesh Panel
- 5: PCI slot Cover
- 6: PCI slot bracket
- 7: Main Chassis
Installation Guide
Step 1: PSU Installation - Initial Chassis Access
To begin PSU installation, first open the top panel of the chassis. This is done by pressing the button located on the rear panel. Subsequently, push the side panel and the front panel outwards from the inside of the case to gain access.
Step 2: Motherboard Installation - Preparation
Before installing the motherboard, remove all multi-functional brackets from the chassis. These brackets may interfere with component placement.
Step 3: Motherboard Installation - Mounting
Insert the motherboard diagonally through the front of the case. Align the motherboard with the standoffs and secure it using the provided screws (typically part A).
Step 4: Graphics Card Installation
First, remove the PCI slot cover and any corresponding PCI slot brackets from the rear of the chassis. Then, insert the graphics card into the appropriate slot on the motherboard. Secure the graphics card to the chassis with a screw.
Step 5: Fan Bracket and Fan Installation
Install the fan brackets onto the fan. Once the brackets are attached, insert the fan assembly into the chassis and secure it in place.
Step 6: Storage Device Installation
Install 2.5" SSDs or 3.5" HDDs onto the multi-functional brackets. After mounting the storage devices onto the brackets, attach these brackets to the corresponding mounting points within the chassis.
Step 7: PSU Installation - Final Mounting
Before mounting the PSU into the case, connect all necessary power cables to the PSU. Place the PSU onto its designated mounting area within the chassis and secure it firmly with screws.
Step 8: Mesh Panel Installation
Install the mesh panels onto their designated locations on the chassis.
Step 9: Strap Handle Installation (If Applicable)
For models equipped with a strap handle, install the strap handles onto the chassis according to the provided instructions.
