Pyle PDRMKIT72 13" 3-Piece Kids/Junior Drum Set

Contents Checklist

First, check the contents of the package and make sure you have everything you need.

1. Bass Drum Head
2. Drum Mute Mat
3. Cymbal
4. Snare drum
5. Tom Tom
6. Bass drum
7. Accessory Box
8. Pedal
9. Bass Drum Bolts
10. Bass Drum Spur
11. Cymbal Holder
12. Drum Tuning Keys
13. Pedal Heads
14. Throne Pedestal
15. Tom / Snare Drum Holder
16. Drumstick
17. Throne seat

Assembly Instructions

1. Take out all the parts from the package and remove the packing bags.

2. Take all the accessories from the accessories box 7.

3. Set up the seat from 14 and 17.

4. Set up the pedal from 8 and 13.

5. Set up the bass drum: take out the bass drum no. 6, remove one side bolt and hoop.

Put the washers on the bass drum boles and put the drum head on. Please pay attention to the logo position when you put the drum head on.

Using the tuning key to make the drum head tight. Please pay attention that, don't tighten one screw too tight without tightening other screws. The correct way is to tighten one screw a little, and then tighten the opposite screw a little, then tighten the besides screw a little, then tighten the left screw a little. Then tighten again by this turn.

6. Set up the bass drum spur 10. Insert it inside the slot of the bass drum in both sides.

7. Put the bass drum on the floor and adjust the length of the bass drum spur.

8. Set up the cymbal holder 11 and tom/snare drum holder 15 on the bass drum.

9. Set up the cymbal.

10. Set up the tom drum on the right, snare drum on the left. Put the logo on drum head in the correct position as pictured.

Set up the pedal on the bass drum hoop by using the screw as shown in the picture below.

11. Finish.

12. If you are afraid it is too loud to annoy your neighborhood, you could put the drum mute mat no. 2 on the drum head.

Setting Drum Mute Mat Method

1. For snare drum and tom drum, you could just put the mute mat on the drum head.
2. For cymbal, you need to take the screw and upper felt out, and put the mute mat instead.

3. Set up the bass drum mute mat. At first, tear the adhesive tape and stick it on the bass drum.

4. Finish.